INEOS UK SNS Limited
1
1. Licence Information
Licence Number: P1741
Licence Round: 26th Round
Licence Type: Traditional
Block Numbers: 42/13b, 42/17 & 42/18
All permissions to publish have been obtained (see Section 9)
2. Licence Synopsis
P1741 was a Traditional 26th Round licence, awarded to RWE Dea UK SNS Limited
(70%) and Sterling Resources (UK) Limited (30%), with a start date of 10/01/2011
(Figure 1). RWE Dea UK was subsequently acquired by L1 Energy (12/03/2015),
becoming DEA UK before being sold on to Ineos in December 2015.
The firm work programme required the acquisition of 450 km2 of 3D seismic,
processed through to PreSDM. There was also a contingent well commitment.
The primary lead (Lochran), identified at the time of application, was a fault
segmented, potentially dip closed structure at Base Permian Unconformity (BPU)
level (Figure 1). There was no 3D coverage over this licence at the time of
application. Consequently, the evaluation was based on a broad grid of 2D seismic.
However, the overburden is complex and depth conversion resulted in a significant
displacement of the Lochran structure westwards, compared with the TWT mapping.
The position and presence of a valid structural closure at BPU level was therefore
questionable. A new proprietary 3D seismic survey was acquired in 2012 and
processed to Pre-SDM (2013) to address this issue.
Interpretation of the new dataset failed to confirm the presence of a significant
closure at BPU level. Consequently, the criteria for drilling were not met and a waiver
of the contingent commitment was sought and obtained from the DECC (26/11/2014)
and the obligation reduced to a drill-or-drop.
A dip and fault closed Intra-Carboniferous lead (Lochran Deep) was, however,
identified within the licence but drilling was not considered to be warranted (Figure 2).
A small BPU feature (named SW Breagh) was also identified in the northern part of
the licence, adjacent to the Breagh field (Figure 2). The structure extended off-block
to the NW into open acreage (42/12), and closure in this direction could not be
confirmed on the available seismic data. A partial relinquishment of the licence was
made effective on 01/01/2015 and a one year extension to the Initial Term of the
licence was granted by the DECC to undertake further evaluation of this lead. A
further 3 month extension was then granted following the sale of DEA UK to Ineos.
However, given the absence of any significant remaining prospectivity, the licence
was subsequently surrendered, effective 15/02/2016.
INEOS UK SNS Limited
2
3. Work Programme Summary
Firm: shoot 450 km2 of 3D seismic and process to PreSDM.
650 km2 of proprietary 3D seismic was acquired by PGS in 2012, using the vessel
Atlantic Explorer. The processing was also undertaken by PGS and the PreSDM
volume was delivered in mid-2013.
Contingent: drill a well to 2225m or Top Visean Great Limestone Unit, whichever
was the shallower. Drilling was contingent upon the 3D seismic dataset:
Enabling clear definition of the Great Limestone unit beneath the Base Permian
Unconformity (BPU) over the northern flank of the Lochran lead.
Providing a significant improvement in confidence as to the presence of the
mapped structure at the BPU.
The new 3D dataset demonstrated the absence of any significant structural closure
at the BPU over the area of the Lochran lead. A waiver of the contingent well
commitment was therefore sought and obtained from the DECC, with the obligation
being reduced to drill-or-drop.
Figure 3 shows the 2D dip line LJ 91-19, running WSW – ENE across Lochran, with
the interpretation as at the time of the licence application. Figures 4a-d provide a
comparison of 2D line LJ 91-19 with a series of outputs from an identically-positioned
arbitrary line extracted from the 2013 3D dataset. Figures 4a & 4b show the 2D line
LJ 91-19 and the time-stretched PreSDM version. Whilst all of the major features are
evident on the 2D line, the 3D data shows a significant improvement in the imaging,
especially at depth. Figures 4c and Figure 4d compare the PreSDM image in TWT
and Depth; note the flatness of the Base Zechstein event (at points A and B) on the
depth section compared with the equivalent time converted section. This comparison
provides significant confidence in the depth conversion presented by the PreSDM
processing, which was subsequently directly used in depth mapping.
Figure 5 shows the 2D strike line LJ 91-02 running S-N across Lochran with the
interpretation as at the time of the licence application. Figures 6a & 6b provide a
comparison of 2D line LJ 91-02 with an equivalent arbitrary line from the 2013 3D
dataset. The 3D data shows a significant improvement in the imaging, especially
within the pre-BPU interval. Again, the flatness of the Base Zechstein event at points
C and D on the depth section (Figure 6d) is clear compared to the equivalent time
converted section (Figure 6c) from the PreSDM dataset.
4. Database
Figure 7 shows the seismic coverage available over P1741 and the wells used to
constrain the seismic velocities for the Pre-SDM during processing (42/18-2 and
42/23-1), and which were also used to identify the key seismic reflectors. The
majority of the 2D is WesternGeco 1992 vintage data; the quality of which is
generally poor below the BPU. The well control is sparse, less than one well per
block.
INEOS UK SNS Limited
3
The proprietary Lochran 3D was acquired for RWE Dea UK by PGS in 2012. The
processing to PreSDM was undertaken by PGS, starting in July 2012 and finishing in
May 2013. Survey area was 650 km2.
5. Prospectivity Update
Lochran Lead: at the time of application this was perceived as a fault segmented,
potentially dip closed structure at BPU level (Figure 1). 3D seismic data was not
available at this time and the mapping was based on a broad grid of vintage 2D
lines. The overburden is complex and depth conversion resulted in a significant
displacement of the Lochran structure westwards, compared with the TWT mapping.
The position and presence of a valid structural closure at BPU level was therefore
questionable. A new proprietary 3D seismic survey was acquired in 2012 and
processed to Pre-SDM (2013) to address this issue.
Interpretation of the new dataset failed to confirm the presence of a significant
closure at BPU level. Consequently, drilling was not warranted and a waiver of the
contingent well commitment was sought and obtained from the DECC (26/11/2014).
However, interpretation of the 3D PreSDM dataset identified two other leads within
the original P1741 licence area:
SW Breagh: This feature was revealed by the 3D data, and straddles the boundary
between blocks 42/12b and 42/18a (Figures 2 & 8). On the available data it is an
elongate NW – SE structure, with a combination top seal comprising Base Namurian
shale on the southern flank and Base Zechstein over the remainder of the trap
(Figures 8 & 9). Given its location, the reservoir interval is expected to comprise
Breagh Zone 1A & 1B sandstones. The principle concerns are trap presence as
mapped and the effectiveness of the proposed but unproven Base Namurian top
seal. An additional non-exclusive PreSTM 3D dataset was purchased in 2015 over blocks 42/12 and 42/13 for the remapping of the Breagh field. Preliminary interpretation of this dataset indicated that SW Breagh is fault bounded to the NW and is therefore relatively small. Consequently, drilling is not considered to be warranted.
Lochran Deep: this feature was revealed by the 3D data and is an intra-
Carboniferous lead that relies on an, as yet, un-proven Base Namurian shale top
seal, with reverse fault closure to the North (Figures 10 & 11). Owing to appreciable
palaeo-burial and subsequent uplift / erosion, reservoir quality is a significant risk,
along with possible cross-fault leakage. Given the risk / resources combination,
drilling of Lochran Deep lacked economic / commercial support.
6. Further Technical Work
The following additional technical work was also undertaken for the evaluation of this
licence:
Duncan McLean undertook a review of the biostratigraphic data to aid the
stratigraphic interpretation and well correlations
An internal review of wells in Quadrants 41 & 42 was completed to assess the
potential for intra-formational seals within the Carboniferous.
INEOS UK SNS Limited
4
Palaeogeographic reconstructions were made for the Brigantian interval to aid
the understanding of reservoir distribution.
Bunter Shale velocities from wells in Quadrants 41 & 42 were analysed and
used to determine the likely maximum depth of palaeo-burial and the potential
impact of this on reservoir quality, as the licence lies within the zone affected
by inversion.
7. Resources and Risk Summary
Resource & Risk Summary
Lead
P
L
D
Stratigraphic
Level
Unrisked Recoverable
Resources Geological
COS %
Risked
P50
MMboe Gas BCF
P90 P50 P10
Lochran
Deep
L Early Carboniferous 43 80 123 15* 2.15
SW
Breagh
L Early Carboniferous 39 52 68 20 1.9
* In this case equates to the probability of achieving a sustainable, commercial flow
rate in an inclined multi-fracced well.
8. Conclusions
There are no significant untested structural closures at the BPU level
Consequently the contingent well obligation was waived
However, two Intra-Carboniferous leads (Lochran Deep and SW Breagh) were
identified using the proprietary (2012/13) 3D dataset. Unfortunately, given the
modest recoverable resources and associated COS, commercial / economic
support for drilling was lacking.
Consequently, the licence was surrendered effective 15/02/2016
9. Clearance
Ineos UK SNS Limited confirms that the OGA has clearance to publish this report
and that all third party ownership rights (on any contained data and/or interpretations)
have been considered and appropriately cleared for publication purposes.
10. Maps and Figures
Please see Following Pages
INEOS UK SNS Limited
5
Figure 1 - Location map showing licence P1741 and the Lochran lead at the time of award
INEOS UK SNS Limited
6
Figure 2 - Map showing licence P1741 post partial relinquishment, effective 09/01/2015 and the
locations of the Lochran Deep and SW Breagh leads.
INEOS UK SNS Limited
7
.
Figure 3 - 2D seismic line LJ 91-19 running WSW – ENE across P1741 showing the interpretation
and the Base Namurian TWT high (Lochran lead) identified at the time of the licence
application. Seismic events tie to well 42/18-2. (Released proprietary ENI seismic data).
INEOS UK SNS Limited
8
Figure 4 Comparison of the vintage 2D line running WSW – ENE seismic with an equivalent arbitrary
line from the 2013 3D Pre-SDM.
4a) 2D seismic line LI-91-19 (TWT), released proprietary ENI seismic data.
4b) Equivalent time converted arbitrary line from proprietary 2013 seismic survey. Refer to
Figure 4 for seismic picks.
WSW ENE
WSW ENE
INEOS UK SNS Limited
9
4c) Time converted arbitrary line from proprietary 2013 seismic survey, as shown in 4b.
4d) Equivalent depth section from PreSDM. Note the flatness of the Base Zechstein (green); moved
up at location A and down at location B.
WSW ENE
WSW ENE
INEOS UK SNS Limited
10
Figure 5- 2D seismic line LJ 91-02 running S – N across P1741 showing the seismic interpretation at
the time of the licence application. Seismic events tie to well 42/18-2. (Released proprietary
ENI seismic data).
INEOS UK SNS Limited
11
Figure 6 Comparison of the vintage 2D S – N seismic line with an equivalent arbitrary line from the
2013 3D Pre-SDM.
6a) 2D seismic line LI-91-02 (TWT), released proprietary ENI seismic data.
6b) Equivalent time converted arbitrary line from proprietary 2013 seismic survey. Refer to Figure 5
for seismic picks.
S N
S N
INEOS UK SNS Limited
12
6c) Time converted arbitrary line from proprietary 2013 seismic survey, as shown in 6b.
6d) Equivalent depth section from PreSDM. Note the flatness of the Base Zechstein (green); moved
up at location C and down at location D.
S
N S
N
INEOS UK SNS Limited
13
Figure 7 Seismic database used for the evaluation of licence P1741
INEOS UK SNS Limited
14
Figure 8 Combined Base Namurian / Base Zechstein depth map showing the SW Breagh Lead
Figure 9 SW – NE seismic and geoseismic sections through the SW Breagh lead showing the trap
style and combination top seal.
INEOS UK SNS Limited
15
Figure 10 Base Namurian depth map, based on the new PreSDM, showing the Lochran Deep lead
Figure 11 Geological cross section through Lochran Deep, illustrating the form of the trap.
Figure 10 shows the location of the section.
Top Related