Y Fridge magnet gear...roughly 5mm diameter by 3mm thick. I set my printer to pause at the correct...
Transcript of Y Fridge magnet gear...roughly 5mm diameter by 3mm thick. I set my printer to pause at the correct...
Summary
This is a print in place fridge magnet I made for my daughter to play with.It should print in one piece, and once you remove the supports, it shouldspin freely. I had to use a little sandpaper to get enough clearance to reallyget it to spin, but it seemed to work.
This is designed to embed a small magnet in the based on the piece,roughly 5mm diameter by 3mm thick. I set my printer to pause at thecorrect layer height so the magnet hole was still open, and I could place amagnet inside. After that, I had the printer resume, and it printed over thetop of the magnet, sealing it in.
Usage: https://youtu.be/UuUJaFBQPIY
Household > Kitchen
printinplace gears fridgemagnet
Steven Quinn
Fridge magnet gear
VIEW IN BROWSER
updated 18. 10. 2019 | published 18. 10. 2019
3D M
ODEL
ONLY
Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES
237.2 KBupdated 18. 10. 2019
Licence: Creative Commons - AttributionCategory: Kitchen & Dining Print Settings
Printer Brand: Prusa
Printer: i3 MK3
Rafts: No
Supports: Yes
Resolution: .2
Infill: 15
Filament: Protopasta HTPLA GunmetalNotes:
When generating support, it needs to be only support coming from thebed. If it's anywhere else, the gear won't spin!
Find source .stl files on Thingiverse.com
The Author has not uploaded any G-codes.Try to search in User G-codes section or generate and upload yourown.
gear_magnet.stl
License
This work is licensed under a Creative Commons (4.0 International License)
Attribution
✖ | Sharing without ATTRIBUTION ✔ | Remix Culture allowed ✔ | Commercial Use ✔ | Free Cultural Works ✔ | Meets Open Definition