Wright flyer I - Banggoodimg.banggood.com/file/products/20160921034732Wright flyer I.pdf · Wright...
Transcript of Wright flyer I - Banggoodimg.banggood.com/file/products/20160921034732Wright flyer I.pdf · Wright...
33
3331
34
circle
32
30
1 2
34
Each propeller by thetwo adhesive
Sliced into propeller blade angle required
Each side of the fuselage is made by a double bond Note proeller support
bracket holes
Pay attention to the hole of propeller’s support bracket
Note that the main beam of the wing bending
Note jack’s position
Note jack’s position
Jack on the wing below the main beam
Jack on the wing below the main beam
Note the bending of wing’s main beam
Propeller assembly bracket(making 2 sets)
Note the leadingedge of the socket
Assemble pilots card bit
Do not plug the wing between pillars
Note the direction of the wing between the strut
Jack on the wing below the main beam
Assemble the wing’s main beam and wing ribs
Completed main beam of the wing
2pcs unnumbered wing ribs combo
unnumbered wing ribs
unnumbered wing ribs
unnumbered wing ribs
Wing Tip
Wing Tip
Completed main beam of the wing
Main beam of the wing(right)
Wing’s main beam(bottom right) Wing’s main beam
(bottom left)
Wing’s main beam(bottom left)
Connection of wing’s main beam
Fuselage/Top wing
A combination of the propeller drive chain
Two unnumbered ribs combination use only in the middle of the wing,each of the main wing only need one.Unless specially marked ribs,all the rest ribs are unnumberesd.
Installation for the leading edge and trailing edge of the wing.
1
2
6
65
5
5
5
3
34
4
26
25
Note the bending of wing tip must be consistent in lower wing
211521
22
23/24
19
28
27
29
20
Wright Flyer I INSTRUCTION MANUALThe Wright Brother’s 1903 Wright flyer
Combination of vertical tail16
16
10
11
14
13
14
13
Pulling Wire Diagram
Installation Position of Emulational Engine and Pilot.
ToolsInstallation of vertical tail
Wright Flyer I INSTRUCTION MANUALThe Wright Brother’s 1903 Wright flyer