ENGLISH

WIRELESS KEYBOARD

904-005

Congratulations on your purchase of the Rock Candy Wireless Keyboard!

FEATURING

ADVANCED FEATURES

• Washable and waterproof (IP66 and IP67 certified) • Durable impact resistant housing• Multi-device shareable nano USB receiver • 30-ft range 2.4 GHz wireless technology• Windows/Mac compatible • Bright, fun colors• Plug and play user-friendly

• Advanced Power Saving Mode – The Rock Candy Wireless Keyboard will go into standby mode when no keypresses are detected for five seconds, extending the life of your batteries. The keyboard immediately exits out of standby mode as soon as a key is pressed.

• Low Battery LED Indicator – Receive advance warning when the battery is beginning to lose charge. Includes the following indicator modes:

When reaching a low power state, the LED will blink slowly, allowing for additional time to replace batteries.

When reaching a critical power state, the LED will blink rapidly and the keyboard will not be operational until batteries are replaced.

Note: If the user continues to use the keyboard, the LED will flash 10 times before turning off.

• 1 Rock Candy Wireless Keyboard • 1 USB Receiver• 2 AAA Batteries • 1 Quick Start Guide (QSG)

ENG

LISH

IMPORTANT / CAUTION STATEMENTSChoking Hazard: Contains small parts that can be a choking hazard for children under 3 years old.

Do not mix different battery types. Risk of explosion may occur.

Do not mix new and old batteries.

Do not expose this product in extreme heat.

Keep the batteries and USB receiver out of reach of children.

For longer battery life, please use non-rechargeable alkaline batteries.

Modifications to this product could void your warranty and your right to operate this product by the FCC.

1

Contents

The keyboard USB receiver is already paired with the keyboard at the factory. However, if you have a replacement USB receiver, you will need to pair it with your keyboard. To pair the keyboard using the USB receiver, please follow these steps:

1) Ensure that the USB receiver is unplugged. 2) Press and hold the “Esc” key, then press the “=” key. The LED for Low Battery will temporarily light up solid to indicate pairing mode. 3) Plug the USB receiver into a USB port on your computer.

Use a Philips screwdriver to remove the two screws from the battery door as shown:

Insert two AAA alkaline (included) batteries with the polarities as shown:1 2

ENG

LISH

2

Connecting Your Keyboard

AAA

AAA

AAAAAA

Close the battery door and securely tighten the screws.

Plug the included USB receiver into any available USB port on your computer.3 4

Pairing Your Keyboard

ENG

LISH

3

Keyboard Anatomy

Rubber Feet

Rubber Feet

Rubber FeetFold-out Tilt Leg Fold-out Tilt LegBattery Compartment

Num Lock LED

Caps Lock LED

Numeric KeypadDirectional KeysMenu KeyFunction Key

Low Battery LED

Windows Key (For PC)

Command Key (For Mac)

PC Shortcut Buttons (Used with Fn key)Media Control Buttons (Used with Fn key)

ENG

LISH

4

PC / Mac Media and Shortcut Function Keys

Multi-Device Receiver Wireless Connection

The receiver can sync with multiple wireless Rock Candy Wireless USB devices (such as the Rock Candy Wireless Mouse), allowing you to free up a USB port on your computer. If you have purchased a Rock Candy Wireless Mouse, you can pair the Rock Candy Wireless Keyboard to the Mouse USB receiver by following these steps:

1) Ensure all USB receivers are unplugged. 2) Press the “Esc” and “=” at the same time until the Low Battery LED lights up solid on the keyboard. 3) Reconnect the mouse USB receiver. The LED on the keyboard will turn off, indicating that the keyboard has successfully paired with the mouse using the same USB receiver. 4) Move the mouse cursor to verify connection with the mouse.

To use the media and shortcut function keys, press the “Fn” key and the corresponding Function key (F1, F2, F3, etc) per the table below:

Fn + Function Key Function Description PC Mac

Launch Media Player Y NVolume Down Y YVolume Up Y YMute Y YSkip – Back Y YSkip – Forward Y YPlay / Pause Y YStop Y NLaunch Web Browser Y NLaunch Email Client Y NLaunch Explorer/Finder Y NOpen/Close Favorites/Bookmark Y N

ENG

LISH

5

Warranty

2 year limited warranty. See www.pdp.com for details.

If the keyboard is not working, please check for the following possible causes:

• Are the batteries installed using the correct polarity?• Is the USB receiver connected to your computer and the drivers finished installing?• If the computer is in sleep mode, and the mouse does not respond, simply click any key on the keyboard to wake from sleep mode. Depending on the speed of your computer, it may take a few seconds to a few minutes to go from sleep to wake mode.

If you still experience problems and further issues arise, please contact PDP Customer Support at www.pdp.com or call toll-free (800) 331-3844 (USA and Canada only).

Troubleshooting

Maintaining Your Keyboard

The Rock Candy Wireless Keyboard is specifically designed to be washed or soaked (as it has passed stringent industry standards for water resistance and water proofing) and ready to be used immediately after a wash. However, please observe the following guidelines for wor-ry-free operation of this product:

• Do not submerge the keyboard deeper than 1 meter (3.3 feet) for more than 30 minutes.• Do not use a dishwasher or electric dryer for this product – hand wash and air dry ONLY.• Avoid using detergents, alcohol based cleaning solutions, or chemical solvents.• For best results, use distilled lukewarm water when washing to prevent residue.• Do not wash or soak the USB receiver, as it is neither washable nor waterproof.• For longer battery life, please use non-rechargeable alkaline batteries.• After replacing batteries or before a wash, always securely tighten the battery door screws (without stripping them).

Regulatory Statements

FCC STATEMENTS: CAUTION: Changes or modifications to this equipment not expressly approved by the man-ufacturer could void the user’s authority to operate the equipment. The equipment complies with FCC RF exposure limits set forth for an uncontrolled environment. The equipment must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protec-tion against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communica-tions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.

FCC ID: X5B-904005T (Keyboard), X5B-904005R (USB Receiver)

This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation

INDUSTRY CANADA: IC ID: 8814A-904005T (Keyboard), 8814A-904005R (USB Receiver)

This device complies with Industry Canada licence RSS standard(s). Operation is subject to thefollowing two conditions:

(1) this device may not cause interference, and(2) this device must accept any interference, including interference that may cause undesired operation of the device.

The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 andcompliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposureand compliance.

ENG

LISH

6

© 2015 Performance Designed Products, LLC. Performance Designed Products, PDP, Rock Candy, Pick Your Flavor, Color is Expression, the flavor names and their respective logos are trademarks and/or registered trademarks of Performance Designed Products, LLC. All other trademarks are the property of their respective owners. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. All rights reserved.

“Le present appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.L’exploitationestautorisée aux deux conditions suivantes:

(1) l’appareil ne doit pas produire de brouillage, et(2) l’utilisateur de l’appareildoit accepter tout brouillage radio électrique subi, mêmesi le brouillage est susceptible d’encompromettre le fonctionnement.

This device complies with part 15 of the FCC Rules. Operation is subject to thefollowing two conditions: (1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference that may cause undesired operation.

REV.B

WWW.PDP.COMwww.pdp.com/support

MADE IN CHINA

Keyboard:Model No.: 904-005TFCC ID: X5B-904005TIC: 8814A-904005TRating: 3VDC/5mA

USB Receiver:Model No.: 904-005RFCC ID: X5B-904005RIC: 8814A-904005RRating: 5VDC/20mA

ENG

LISH

7

Warranty

Regulatory Statements (cont.)