1

Spike-2 Power TapRevised: 02/15/19

Tools needed:

Safety glasses

Pinball glass protectant

DANGER ELECTRICAL SHOCK

 Warnings:

Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.

    SAFETY GLASSES are also recommended while working with or installing pinball parts.

Please follow these safety instructions as well as all installation instructions. Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities in our Terms of Service prior to installation.

Images included in these instructions are of an installed prototype and may vary from your product slightly.

WPC Power tap

Fits WPC games: Black Rose, Bram Stoker's Dracula, Corvette, Creature from the Black Lagoon, Demolition Man, Dirty Harry, Doctor Who, Fish Tales, Funhouse, Indiana Jones: The Pinball Adventure, Indianapolis 500, Jack-Bot, Johnny Mnemonic, Judge Dredd, No Fear: Dangerous Sports, Popeye Saves the Earth, Red & Ted's Road Show, Star Trek: The Next Generation, Terminator 2, The Addams Family, The Flintstones, The Getaway, The Machine: Bride of Pinot, The Shadow, Theatre of Magic, Twilight Zone, White Water, Who Dunnit, World Cup Soccer.

Steps:

1. Unplug game2. Unlock and remove translate. Store in a safe place.3. Place a towel or blanket on your pinball glass.4. Remove DMD/speaker panel and lay face down on towel.5. Locate plug J138, J139, J140 or J141. These are plugs that supply 5V and 12 V.6. Unplug any of the three plugs. Notice at the right, most positions are the key and don’t have a

pin. See picture below.

2

Spike-2 Power TapRevised: 02/15/19

3

Spike-2 Power TapRevised: 02/15/19

7. Unplug any of the 3 plugs. Notice at the right most position, that is the key and does not have a pin.

4

Spike-2 Power TapRevised: 02/15/19

8. Get WPC Power Tap. The power tap has a plug to plug into your game, and a Z-connect to plug the original plug into. The tap offers a standard 3 pin Molex that offer 5 volt and 12 volts. The tap also offers a 5.5mm x 2.1mm barrel connector that supplies 12 volts which is a common plug used on many LED products.

5

Spike-2 Power TapRevised: 02/15/19

9. Plug the power tap into that plug. The position that does not have a wire matches up to the key.

10. Put the Z-connect in the other end of the power tap. Notice the 3 pins of the Z-connect line up to the 3 wires.

6

Spike-2 Power TapRevised: 02/15/19

11. The original plug in the game will plug into the other end of the Z-connect.

DANGER ELECTRICAL SHOCK

12. This leaves the Molex plug and the 5.5mm x 2.1mm available to plug additional mods in your game.

7

Spike-2 Power TapRevised: 02/15/19