Visions of Sugarplums Christmas Pillowcases

download Visions of Sugarplums Christmas Pillowcases

of 6

description

Visions of Sugarplums Christmas Pillowcases

Transcript of Visions of Sugarplums Christmas Pillowcases

  • Published on Sew4Home

    Visions of Sugarplums Christmas Pillowcases Editor: Liz JohnsonFriday, 27 November 2009 9:00

    Do you have family and friends staying at your home for the holidays? Yes! Do you have time and money to make all newholiday bed linens for your guest room? No! Then just change up the pillowcases. It's a super fast, easy and inexpensive wayto add a little holiday cheer. Our instructions show you how to make two standard size pillowcases (for standard 20" x 26"pillows) using just 1 yards of main fabric and yard of contrasting trim fabric.If you have larger or smaller pillows you'd like to make cases for, simply adjust our measurements to accommodate your pillowsize. For example, king pillows are normally 20" x 36" so the width remains the same but you need an additional 10" infinished length (20" in cut length). This means rather than cutting the fabric for the body of the pillowcase 21" x 53", you shouldcut it 21" x 73". However, two yards of fabric equals 72". This is where the 'fudge factor' comes in. Can you 'fudge' a little tosave some money? I'd say, 'yes.'You can totally get away with this slightly shorter length to avoid buying more than a standardtwo yard cut. Your trim piece won't extend quite as far over the edge of the pillow, but will still cover it nicely.

    Sewing Tools You NeedAny Sewing Machine (we recommend the Janome MyStyle 100)

    Fabric and Other Supplies

    1

  • Fabric amounts shown are for TWO pillowcases.Fabric for body of pillowcase: 1 yards of 45" wide fabric, we used: Mary Engelbreit's The Caroler in Snowflake WinterGardenFabric for pillowcase trim: yard of 45" wide fabric, we used: Mary Engelbreit's The Caroler in Gold Stocking Stripe NOTE: We made a second set of pillowcases using Mary Engelbreit's The Caroler in Pine Needle Garden for the bodyof the pillowcase and The Caroler in Gold Stocking Stripe for the trim.2 standard 20" x 26" bed pillowsAll purpose threadContrasting color thread for topstitchingSee-through rulerFabric pencilIron and ironing boardScissors or rotary cutter and matStraight pins

    Getting Started1. From the fabric for the body of the pillowcase, cut two rectangles, 21" x 53".2. From the fabric for the pillowcase trim, cut two rectangles, 9" x 41".

    2

  • At Your Sewing Machine & Ironing BoardPillowcase body

    1. Fold one pillowcase body rectangle in half, right sides together, so it is now: 21" x 26".

    2. Pin the two 26" sides together. Stitch both sides, using a " seam allowance.

    3

  • 3. Clip corners and turn pillowcase right side out. Push out the trimmed corners from the inside to make nice, squarecorners on the outside. Use your finger or a blunt edge tool, like a large knitting needle. Press.

    4. Repeat for second pillowcase body.

    Pillowcase trim1. Press a double-fold hem along one raw edge of the pillowcase trim piece. Turn up the edge " and press, then turn up

    another 4" and press again

    2. Unfold the pressed hem. Your fold lines will remain.

    3. Fold the 9" x 41" trim piece in half, right sides together, so it is now: 9" x 20".4. Using a " seam allowance, stitch the along the 9" raw edge. Press seam open.

    4

  • 5. You now have a 9" x 40" circle of trim.6. Repeat for second pillowcase trim piece.

    Finish pillowcase1. Slip your trim circle" over the open bottom end of your pillowcase body, right sides together, matching raw edges and

    aligning the trim's seam with one of the pillowcase body's side seams. You are matching the raw edge of the pillowcaseopening with the non-folded" raw edge of your trim piece. Pin all around.

    2. Using a " seam, stitch all around the pillowcase opening. Press the seam towards the trim.3. Re-fold' the raw edge of your trim, following the pre-pressed trim lines. Fold " and then 4".4. Bring the folded edge of the trim around to the inside of the pillowcase. The folded edge of the trim should just overlap the

    inside pillowcase/trim seam. Pin in place from the front.

    5. As you look at your pillowcase from the front, you should have 4" of trim showing from seam to folded edge.6. Topstitch " in from the seam to secure trim. We used a contrasting color thread for a decorative touch. Press.7. Repeat to finish second pillowcase.

    Contributors Project Design: Alicia Thommas Sample Creation: Aimee McGaffey

    Tags:

    Pillowcase

    5

  • Bed Linens

    Visions of Sugarplums Christmas Pillowcase for Kids

    This project and patterns (if any) may be downloaded for personal use only. No electronic or printed reproduction permittedwithout the prior written consent of Sew4Home LLC.

    Copyright 2009-2015 Sew4Home LLC. All Rights Reserved.Source URL: http://www.sew4home.com/projects/bed-linens/visions-sugarplums-christmas-pillowcases

    6