Vintage Halloween Layout By Maiko Miwa Cut out the frame from the Love Potion design in the Vintage Voyage page. Then cut out two clocks, two bats and the love potion label. Adhere your photo to the back of the frame. Cut out the frame from the Lucky Spells design in the Vintage Voyage page. Adhere your photo to the back of the frame. Cut out the cards to use as a frame for the next photo, only cutting out the bottom cards and the upper right corner cards as shown in the photo below. Then cut out the Good fortunes For You words into a single rectangular shape. Next, cut the entire Dr. Dreadful's design from the same Vintage Voyage page to use as the back of your

next photo. Center and adhere your photo to the Dr. Dreadful's design and then adhere the cards as the frame placing them in the same positions you cut them out...top right corner and bottom.

First, cut out the stamp frames and then cut out the oval frames from the stamp frames. Note: If you wish to use the hats later in your pictures, cut them out and save them. Place the oval frame over your photo to and frame your photo. Then adhere the frame to your photo. Next, cut around the outside of the oval to shape it to the oval. Cut a piece of paper that you're not going to use 3.25 x 2.75" times three to create three separate pieces. Adhere one piece of paper to the back of each stamp frame. Using a three dimensional sticker, adhere the oval photo to the stamp. Cut out two designs into one piece from the Nevermore page, as shown in the photo to the right. Cut out whatever animals or designs you wish to use in your project from the same sheet. Example: owl, crow, moth and bat. Cut out the So Very Curious crow frame and the black cat frame from the Frightful Folly page. Adhere the crow frame to the back of the black cat frame with a three dimensional sticker placing the edge of the black cat frame flush to the inside edge of the top left corner as shown in the photo to the right.

Cut out the two connected stamps as one piece and one book lock which is on the back of the same design on the Vintage Voyage page. Cut out the Wishing You A Happy Halloween design and the two hot air balloons as one design which are on the back of the same design on the Vintage Voyage page. Cut out the red flower frame from the Vintage Voyage page as show in the photo below. Using the two book cover-like designs you cut out earlier, adhere them together as shown below. Next, adhere the book and the Wishing You A Happy Halloween phrase to the frame.

Place the blocks and cutout pieces on the Steampunk Spells page arranging them however you like.

Simple version Decorated version