Vibrat Damp

49
FORCED VIBRATION & DAMPING

description

read it :P

Transcript of Vibrat Damp

Page 1: Vibrat Damp

FORCED VIBRATION & DAMPING

Page 2: Vibrat Damp

Damping

a process whereby energy is taken from the vibrating system and is being absorbed by the surroundings.

Examples of damping forces: internal forces of a spring, viscous force in a fluid, electromagnetic damping in galvanometers, shock absorber in a car.

Page 3: Vibrat Damp

Free Vibration

Vibrate in the absence of damping and external force

Characteristics: the system oscillates with constant frequency and

amplitude the system oscillates with its natural frequency the total energy of the oscillator remains constant

Page 4: Vibrat Damp

Damped Vibration (1)

The oscillating system is opposed by dissipative forces.

The system does positive work on the surroundings.

Examples: a mass oscillates under water oscillation of a metal plate in the magnetic field

Page 5: Vibrat Damp

Damped Vibration (2)

Total energy of the oscillator decreases with time

The rate of loss of energy depends on the instantaneous velocity

Resistive force instantaneous velocity i.e. F = -bv where b = damping coeff

icient Frequency of damped vibration < Frequency

of undamped vibration

Page 6: Vibrat Damp

Types of Damped Oscillations (1)

Slight damping (underdamping) Characteristics: - oscillations with reducing amplitudes - amplitude decays exponentially with time - period is slightly longer - Figure - constant a.......

4

3

3

2

2

1 aa

aa

aa

Page 7: Vibrat Damp

Critical damping No real oscillation Time taken for the displacement to become

effective zero is a minimum Figure

Types of Damped Oscillations (2)

Page 8: Vibrat Damp

Heavy damping (Overdamping) Resistive forces exceed those of critical da

mping The system returns very slowly to the equili

brium position Figure Computer simulation

Types of Damped Oscillations (3)

Page 9: Vibrat Damp

the deflection of the pointer is critically damped

Example: moving coil galvanometer (1)

Page 10: Vibrat Damp

Damping is due to induced currents flowing in the metal frame

The opposing couple setting up causes the coil to come to rest quickly

Example: moving coil galvanometer (2)

Page 11: Vibrat Damp

Forced Oscillation

The system is made to oscillate by periodic impulses from an external driving agent

Experimental setup:

Page 12: Vibrat Damp

Characteristics of Forced Oscillation (1)

Same frequency as the driver system Constant amplitude Transient oscillations at the beginning which

eventually settle down to vibrate with a constant amplitude (steady state)

Page 13: Vibrat Damp

In steady state, the system vibrates at the frequency of the driving force

Characteristics of Forced Oscillation (2)

Page 14: Vibrat Damp

Energy

Amplitude of vibration is fixed for a specific driving frequency

Driving force does work on the system at the same rate as the system loses energy by doing work against dissipative forces

Power of the driver is controlled by damping

Page 15: Vibrat Damp

Amplitude

Amplitude of vibration depends on the relative values of the natural frequency

of free oscillation the frequency of the driving force the extent to which the system is damped

Figure

Page 16: Vibrat Damp

Effects of Damping

Driving frequency for maximum amplitude becomes slightly less than the natural frequency

Reduces the response of the forced system Figure

Page 17: Vibrat Damp

Phase (1)

The forced vibration takes on the frequency of the driving force with its phase lagging behind

If F = F0 cos t, then x = A cos (t - ) where is the phase lag of x behind F

Page 18: Vibrat Damp

Phase (2)

Figure 1. As f 0, 0 2. As f , 3. As f f0, /2 Explanation

When x = 0, it has no tendency to move. maximum force should be applied to the oscillator

Page 19: Vibrat Damp

When oscillator moves away from the centre, the driving force should be reduced gradually so that the oscillator can decelerate under its own restoring force

At the maximum displacement, the driving force becomes zero so that the oscillator is not pushed any further

Thereafter, F reverses in direction so that the oscillator is pushed back to the centre

Phase (3)

Page 20: Vibrat Damp

On reaching the centre, F is a maximum in the opposite direction

Hence, if F is applied 1/4 cycle earlier than x, energy is supplied to the oscillator at the ‘correct’ moment. The oscillator then responds with maximum amplitude.

Phase (4)

Page 21: Vibrat Damp

Barton’s Pendulum (1)

The paper cones vibrate with nearly the same frequency which is the same as that of the driving bob

Cones vibrate with different amplitudes

Page 22: Vibrat Damp

Cone 3 shows the greatest amplitude of swing because its natural frequency is the same as that of the driving bob

Cone 3 is almost 1/4 of cycle behind D. (Phase difference = /2 )

Cone 1 is nearly in phase with D. (Phase difference = 0)

Cone 6 is roughly 1/2 of a cycle behind D. (Phase difference = )

Barton’s Pendulum (2)

Previous page

Page 23: Vibrat Damp

Hacksaw Blade Oscillator (1)

Page 24: Vibrat Damp

Damped vibration The card is positioned in such a way as to produce

maximum damping The blade is then bent to one side. The initial position

of the pointer is read from the attached scale The blade is then released and the amplitude of the

successive oscillation is noted Repeat the experiment several times Results

Hacksaw Blade Oscillator (2)

Page 25: Vibrat Damp

Forced Vibration (1)

Adjust the position of the load on the driving pendulum so that it oscillates exactly at a frequency of 1 Hz

Couple the oscillator to the driving pendulum by the given elastic cord

Set the driving pendulum going and note the response of the blade

Page 26: Vibrat Damp

In steady state, measure the amplitude of forced vibration

Measure the time taken for the blade to perform 10 free oscillations

Adjust the position of the tuning mass to change the natural frequency of free vibration and repeat the experiment

Forced Vibration (2)

Page 27: Vibrat Damp

Plot a graph of the amplitude of vibration at different natural frequencies of the oscillator

Change the magnitude of damping by rotating the card through different angles

Plot a series of resonance curves

Forced Vibration (3)

Page 28: Vibrat Damp

Resonance (1) Resonance occurs when an oscillator is acted

upon by a second driving oscillator whose frequency equals the natural frequency of the system

The amplitude of reaches a maximum The energy of the system becomes a maximum The phase of the displacement of the driver

leads that of the oscillator by 90

Page 29: Vibrat Damp

Resonance (2)

Examples Mechanics:

Oscillations of a child’s swing Destruction of the Tacoma Bridge

Sound: An opera singer shatters a wine glass Resonance tube Kundt’s tube

Page 30: Vibrat Damp

Electricity Radio tuning

Light Maximum absorption of infrared waves by a NaCl cryst

al

Resonance (3)

Page 31: Vibrat Damp

Resonant System

There is only one value of the driving frequency for resonance, e.g. spring-mass system

There are several driving frequencies which give resonance, e.g. resonance tube

Page 32: Vibrat Damp

Resonance: undesirable

The body of an aircraft should not resonate with the propeller

The springs supporting the body of a car should not resonate with the engine

Page 33: Vibrat Damp

Demonstration of Resonance (1)

Resonance tube Place a vibrating tuning fork above the mouth of

the measuring cylinder Vary the length of the air column by pouring

water into the cylinder until a loud sound is heard The resonant frequency of the air column is then

equal to the frequency of the tuning fork

Page 34: Vibrat Damp

Sonometer Press the stem of a vibrating tuning fork against th

e bridge of a sonometer wire Adjust the length of the wire until a strong vibratio

n is set up in it The vibration is great enough to throw off paper ri

ders mounted along its length

Demonstration of Resonance (2)

Page 35: Vibrat Damp
Page 36: Vibrat Damp

Oscillation of a metal plate in the magnetic field

Page 37: Vibrat Damp

Slight Damping

Page 38: Vibrat Damp

Critical Damping

Page 39: Vibrat Damp

Heavy Damping

Page 40: Vibrat Damp

Amplitude

Page 41: Vibrat Damp

Phase

Page 42: Vibrat Damp

Barton’s Pendulum

Page 43: Vibrat Damp

Damped Vibration

Page 44: Vibrat Damp

Resonance Curves

Page 45: Vibrat Damp

Swing

Page 47: Vibrat Damp

Resonance Tube

A glass tube has a variable water level and a speaker at its upper end

Page 48: Vibrat Damp

Kundt’s Tube

Page 49: Vibrat Damp

Sonometer