V600/V800 Vertical Cable Tray Instructions

parts

tools

1 2

(2) Vertical Cable Trays

T30 Torx Driver

Align tray mounting clips and center mounting bracket intotop and bottom cabinet rails. Orient the rails so that cen-ter mounting bracket points down and the PDU mountingkeyholes (if present) are properly oriented

Slide top and bottom clip tabs upward and secure usingT30 Torx Driver.

X2

INS_100.24082.00_V600_V800_Tray_A 10/4/16 9:30 AM Page 1

To assist safe installations, comply with the following:A. Use caution when installing or modifying

telecommunications circuits.

B. Never touch uninsulated wire terminals unlessthe circuit has been disconnected.

C. Never install this device in a wet location.

D. Never install wiring during a lightning storm.

V600/V800 Vertical Cable Tray Instructions

4If mounting PDUs, align PDU button mounting tabs with theappropriate mounting keyholes and then slide down to secureonto tray.

If managing cabling, use t-shaped cutouts for cable ties or 9.5mm(0.375 in.) square holes for Siemon’s ¼-turn cable managementaccessories.

www.siemon.com

© 2

016

The

Sie

mon

Com

pany

R

ev.

A

10/1

6

100.2

4082.0

0

Global HeadquartersWatertown, Connecticut USA

Tel: (1) 866-548-5814

For a complete listing of our global offices visit our web site

3

INS_100.24082.00_V600_V800_Tray_A 10/4/16 9:30 AM Page 2