Using the CIOKS DC10 to power a maximum of three Eventide ... DC10 with Eventide -ver. 1.1.pdfTo...
Transcript of Using the CIOKS DC10 to power a maximum of three Eventide ... DC10 with Eventide -ver. 1.1.pdfTo...
![Page 1: Using the CIOKS DC10 to power a maximum of three Eventide ... DC10 with Eventide -ver. 1.1.pdfTo power one Eventide stompbox, connect to the DC10's Outlet 10: 1 To power a second Eventide](https://reader036.fdocuments.net/reader036/viewer/2022062611/61289d7c42119d51b90f6fc4/html5/thumbnails/1.jpg)
Using the CIOKS DC10 to power a maximum of three Eventide Factor Series Stompboxes
For support contact [email protected]
However, to power three Eventide StompboxesMake sure the DIP Switchesare set to engage the Mergefeature of Outlets 5+6, and to set Outlet 6 to 12V like this:
DIP Switches:To power one or twoEventide Stompboxesthe DIP Switches on the back of the DC10 canremain at their defaultsettings.
1 2 3 4 5 6ON ON
To power one Eventide stompbox,connect to the DC10's Outlet 10:
1
To power a second Eventide stompbox,connect to the DC10's Outlet 8:
2
To power a third Eventide Stompbox, connect to the DC10's Outlet 6:
3
Connect only with thegreen tipped to single black tippedpower cables.(Type 4 - green with 5.5/2.5mm center positive DC-plug.)