IEEE Standard Letter Symbols for Quantities Used in Electrical Science and Electrical Engineering
Unit 2 Electrical Quantities and Ohm’s Law
description
Transcript of Unit 2 Electrical Quantities and Ohm’s Law
![Page 1: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/1.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Objectives:
• Define a coulomb.
• Define an ampere.
• Define a volt.
• Define an ohm.
• Define a watt.
![Page 2: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/2.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Objectives:
• Compute electrical values using Ohm’s law.
• Discuss basic types of circuits.
• Use the Ohm’s wheel charts.
![Page 3: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/3.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
A coulomb is a quantity measurement for electrons.
One coulomb contains 6.25 x 1018 electrons, or 6,250,000,000,000,000,000 electrons.
![Page 4: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/4.jpg)
Unit 2 Electrical Quantities and Ohm’s LawThe ampere is a measurement of the amount of
electricity that is flowing through a circuit.
One ampere (A) is defined as one coulomb of electricity flowing past a given point in one second.
![Page 5: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/5.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Compare and contrast these two systems.
![Page 6: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/6.jpg)
Unit 2 Electrical Quantities and Ohm’s LawThere are two theories about current flow.
Electron flow theory describes current flow from negative to positive.
Conventional current flow theory states electrical current flows from positive to negative.
![Page 7: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/7.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Conventional current flow theory and electron flow theory.
![Page 8: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/8.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Electrons moving from atom to atom.
![Page 9: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/9.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Electrical sources are divided into two basic types:– Direct Current (DC) which is unidirectional
(one way).
– Alternating Current (AC) which is
bidirectional (two way, or back and forth).
![Page 10: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/10.jpg)
Unit 2 Electrical Quantities and Ohm’s LawA complete path must exist before electricity can
flow through a circuit.
A circuit with a complete path for electrical flow is called a closed circuit.
If the circuit path is incomplete or broken, this is called an open circuit.
![Page 11: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/11.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
A simple switch closes and opens an electrical circuit.
![Page 12: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/12.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
A short circuit has an unintended shorter pathway.
![Page 13: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/13.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
The basic principle of the instantaneous effect of electric impulses.
![Page 14: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/14.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
The impulse of electricity can travel faster than light. It would take light 1.3 seconds to travel around the earth 10 times. If a wire were wrapped around the earth 10 times, when the switch was closed the light would come on almost instantly.
![Page 15: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/15.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
A volt or voltage is electrical pressure.
![Page 16: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/16.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
An ohm is the unit of resistance or opposition to the flow of electricity.
![Page 17: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/17.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
The watt is the unit of electrical power.
![Page 18: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/18.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Force equals flow rate times pressure.
![Page 19: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/19.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Amperes times volts equals watts.
![Page 20: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/20.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Common power units.
![Page 21: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/21.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Ohm’s law states that in a DC (Direct Current) circuit, the current is directly proportional to the voltage and inversely proportional to the resistance.
E(volts) = I(amps) x R(ohms)
![Page 22: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/22.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Ohm’s Law Symbols:P is the symbol for Watts.E is the symbol for Volts.I is the symbol for Amperes.R is the symbol for Resistance or Ohms.
![Page 23: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/23.jpg)
Unit 2 Electrical Quantities and Ohm’s LawOhm’s Law states that it takes one volt to push
one ampere through one ohm.
E = Volts
I = Amps
E = I x R
R = Resistance
![Page 24: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/24.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Using the Ohm’s law chart.
E = I x R I = E / R R = E / I
![Page 25: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/25.jpg)
Unit 2 Electrical Quantities and Ohm’s LawAdding P (watts) to the Ohm’s law chart.
P = E2 / RP = E x IP = I2 x R
R = E / IR = P / I2
R = E2 / P
I =I = P / EI = E / R
E = E = I x RE = P / I
RP
PR
RP
PR
![Page 26: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/26.jpg)
Unit 2 Electrical Quantities and Ohm’s LawRemember:
E = EMF, or voltage
I = intensity of current, or amperage
R = resistance in ohms
P = power in watts
E(volts) = I(amperes) x R(ohms)P(watts) = I(amperes) x E(volts)
![Page 27: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/27.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
![Page 28: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/28.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Metric Units
![Page 29: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/29.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Review:1. A coulomb is a quantity measurement of
electrons.2. An ampere (A) is one coulomb per second.3. Either the letter I, which stands for intensity
of current flow, or the letter A, which stands for amperes, can be used in Ohm’s law formulas.
![Page 30: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/30.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Review:4. Voltage is referred to as electric pressure,
potential difference, or electromotive force. An E or a V can be used to represent voltage in Ohm’s law formulas.
5. An ohm (Ω) is a measurement of resistance (R) in an electric circuit.
![Page 31: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/31.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Review:6. The watt (W) is a measurement of power in
an electrical circuit. It is represented by either a W or a P (power) in Ohm’s law formulas.
7. Electric measurements are generally expressed in engineering notation.
![Page 32: Unit 2 Electrical Quantities and Ohm’s Law](https://reader036.fdocuments.net/reader036/viewer/2022081417/56814790550346895db4c0cb/html5/thumbnails/32.jpg)
Unit 2 Electrical Quantities and Ohm’s Law
Review:8. Engineering notation differs from the
standard metric system in that it uses steps of 1000 instead of steps of 10.
9. Before current can flow, there must be a complete circuit.
10. A short circuit has little or no resistance.