U Rines y Cauchos Chevrolet Impala

3
TW SUSPENSION TIRE AND WHEEL WHEEL AND TIRE COMPONENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TW-1 REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TW-1 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TW-1 WHEEL AND TIRE SYSTEM INSPECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TW-2 TO INDEX

description

Rines y Cauchos del Chevrolet IMpala, que nota de vehículo, muy como y rápido

Transcript of U Rines y Cauchos Chevrolet Impala

Page 1: U Rines y Cauchos Chevrolet Impala

TW

SUSPENSION

TIRE AND WHEEL

WHEEL AND TIRECOMPONENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TW-1REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TW-1INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TW-1

WHEEL AND TIRE SYSTEMINSPECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TW-2

TO INDEX

Page 2: U Rines y Cauchos Chevrolet Impala

TW–1 TIRE AND WHEEL - WHEEL AND TIRE

TW

SUSPENSIONTIRE AND WHEELWHEEL AND TIRECOMPONENTS

REMOVAL1. REMOVE WHEEL AND TIRE

(a) Remove the wheel cap S/A. (b) Jack up the vehicle.(c) Remove the 5 nut hubs.(d) Remove the wheel disk.

INSTALLATION1. INSTALL WHEEL AND TIRE

(a) Install the wheel and the tire.(b) Install the 5 nut hubs.

Torque: 103 N*m (1050 kgf*cm)(c) Jack down the vehicle.(d) Install the wheel cap S/A.

×5

T=103.0{1050}

TIGHTENING TORQUE [N*m{kgf*cm}]

WHEEL AND TIRE

C140922J01

Page 3: U Rines y Cauchos Chevrolet Impala

TIRE AND WHEEL - WHEEL AND TIRE SYSTEM TW–2

TW

SUSPENSIONTIRE AND WHEELWHEEL AND TIRE SYSTEMINSPECTION1. CHECK TIRE

(a) Check for a size and wear.(b) Check for cracks and damage.(c) Check the tire pressure.

Standard

(d) Check for modification of the suspension and damage to anyparts of the wheel.

(e) Check the tire runout.Maximum tire runout:

1.4 mm (vertical)2.0 mm (horizontal)

HINT:Remove the wheel assembly from the vehicle, and measure therunout of the wheel assembly when it is off the vehicle.

(f) Check that the bolts on the wheel-related parts are properlytightened.

(g) Check the related parts for looseness.

2. ROTATE TIRE(a) Rotate the tires as shown in the illustration.

3. CHECK WHEEL BALANCE(a) Check the wheel balance (off-the-car balance).(b) Adjust the wheel balance (off-the-car balance).

Imbalance after adjustment:11 g or less

(c) If tire vibration occurs even after adjusting the off-the-carbalance, adjust the on-the-car balance.

4. CHECK FRONT AXLE HUB BEARING

Tire SizeTire Pressure (Front

Wheels)kPa (kgf/cm2)

Tire Pressure (Rear Wheels)

kPa (kgf/cm2)

215/65R16 2.0 2.0

235/60R16 2.1 2.1

C050798J01

Front

G023600J01

C080976J01

TO INDEX TO NEXT SECTION