Tulane University - Office of Environmental Health & Safety (OEHS) Electrical Safety For Office,...

Tulane University - Office of Environmental Health & Safety (OEHS)

Electrical Safety

For Office, Facility, and Laboratory Employees

Tulane University

October 2006


Objectives

• To identify proper use of electrical extension cords, multiple outlet strips, and portable electric heaters.

• To identify safe electrical practices. • To review Electrical Safety for Facilities

Services • To review equipment repair/component

replacement procedures for Facility DSRs


Electrical Extension Cords• Grounded, heavy gauge

extension cords are OK for temporary use with portable equipment, e.g., maintenance power tools, audio-visual equipment, housekeeping appliances.

• The use of extension cords in lieu of permanent wiring is a fire code violation.


Multiple Outlet Strips

• Multiple outlet strips with circuit breaker or fuse and power cord no > 6 ft. may be used for computer work stations only.

• Use of linked cord-sets as shown in photo is prohibited.


Electrical Safety

• Contact Facilities Services if additional electrical outlets are needed OR if you see an obvious electrical hazard like this →


Portable Electric Heaters

• Prohibited except if provided by Facilities Services/Plant Operations when heating issues cannot be resolved.

• Contact Facilities Services/Plant Operations regarding heating issues.


Electrical Panels

• Keep panels unobstructed & provide a 36 inch clearance.

• Keep panels free of combustible & flammable storage.

(The gray rectangles in the photo are electrical panels which are blocked by combustible materials.)


Safety Practices

• Purchase & use equipment with grounded (3-prong) power cords or double-insulated appliances.

• Improper use of adapters or “cheaters” on grounded plugs is a fire code violation.

• Contact OEHS or Facilities Services for more information.


Safety Practices

• Ground Fault Circuit Interrupters (GFCIs) monitor current going in and out of an electrical device. If an imbalance is sensed, the GFCI shuts off the power instantly to prevent injury.

• GFCIs are installed in electrical outlets where there is a greater risk of electric shock – e.g., wet areas (near sinks/faucets).


Safety Practices

• Keep combustible materials/flammable liquids away from electrical appliances & sources of heat:– Bacti-cinerators, Bunsen burners, hot plates– Coffee pots, ovens – Heat guns, light bulbs, etc.

• Do not overload outlets


Safety Practices

• Do not run power cords under carpeting, across walkways, or through doorways and walls→

• Do not use metal ladders near energized electrical equipment.


Defective Equipment

• Examples of defective equipment:– Missing ground prong– Spliced/taped/broken power cord– Frayed or exposed wire– Sparks, smoke, or shock when energized.

• Take equipment out of service and tag it to warn others.

• Report hazard for repair by trained/qualified personnel or discard equipment.


Electrical Safety for Facilities Services

• Lockout and tagout electrical switches when doing repair work.

• See Equipment Lockout/Tagout in “Facilities,” (Section 24 of Environmental Health and Safety Policies & Procedures Manual.)



• When working on electrical distribution panels, sub-panels, motor controls, or fixed equipment, ensure power sources are disconnected and tagged out of service, then test to ensure power is off before beginning work.

• Wear proper Personal Protective Equipment & use proper safety equipment.



• Upon completion, test the system before putting it in service, restore controls to normal operations, remove tags, and replace panel covers.


Facility DSRs

• If your department has fixed or portable electrical equipment such as drills, table saws, band saws, etc., then their power sources must be disconnected and tagged out of service during repairs, replacement of components, or other work.

• Follow the same procedures as per Electrical Safety for Facilities Services and/or manufacturer’s instructions


Review• Extension cords are only a temporary

source of power.

• Multiple outlet strips may only be used with computer configurations.

• Keep electrical panels unobstructed and free of nearby combustible materials.

• GFCIs should be installed on electrical outlets near wet areas.


Review

• Keep combustibles/flammables away from heat sources.

• Inspect electrical equipment. Remove defective equipment from service and tag.

• Follow the appropriate Lockout/Tagout procedures when conducting repair or component work on equipment.

Tulane UniversityOffice of Environmental Health & Safety (OEHS)

www.som.tulane.edu/oehs Karen Douglas (Uptown), Environmental Health & Safety Specialist

(504) 865-5307 / [email protected] Welch (Downtown), Occupational Safety Manager

(504) 988-3996 / [email protected]

If unable to proceed to quiz, type the link below into your browserhttps://pandora.tcs.tulane.edu/ehs/enterssn.cfm?testnum=9

Proceed to Quiz

http://www.som.tulane.edu/oehs

mailto:[email protected]

mailto:[email protected]

https://pandora.tcs.tulane.edu/ehs/enterssn.cfm?testnum=9

Tulane University - Office of Environmental Health & Safety (OEHS) Electrical Safety For Office,...

Documents

Transcript of Tulane University - Office of Environmental Health & Safety (OEHS) Electrical Safety For Office,...