Transport Independent SDP Bandwidth Parameter
description
Transcript of Transport Independent SDP Bandwidth Parameter
![Page 1: Transport Independent SDP Bandwidth Parameter](https://reader036.fdocuments.net/reader036/viewer/2022083006/568139f0550346895da1a8e1/html5/thumbnails/1.jpg)
Transport Independent SDP Bandwidth Parameter
Draft-westerlund-mmusic-sdp-bwparam-01.txt
Author:
Magnus Westerlund
![Page 2: Transport Independent SDP Bandwidth Parameter](https://reader036.fdocuments.net/reader036/viewer/2022083006/568139f0550346895da1a8e1/html5/thumbnails/2.jpg)
Magnus Westerlund
Outline
• The Problem• A Solution• The Way Forward• Open Issues
![Page 3: Transport Independent SDP Bandwidth Parameter](https://reader036.fdocuments.net/reader036/viewer/2022083006/568139f0550346895da1a8e1/html5/thumbnails/3.jpg)
Magnus Westerlund
The Problem (1 of 2)
• The most commonly used SDP bandwidth modifier is AS:Application specific maximum.
• SDP and “b=“ is used to signal bandwidth in SIP, SAP, and RTSP.
• Usage of NAT-PT (Network Address Translation – Protocol Translation) as an IPv4 to IPv6 transition mechanism does not work for “b=AS”.
• Other mechanisms altering the overhead are also problematic to take into consideration.
![Page 4: Transport Independent SDP Bandwidth Parameter](https://reader036.fdocuments.net/reader036/viewer/2022083006/568139f0550346895da1a8e1/html5/thumbnails/4.jpg)
Magnus Westerlund
The Problem (2 of 2)
• In some cases it is impossible to know which IP version that is included in AS.
• The packet rate is required for conversions.
![Page 5: Transport Independent SDP Bandwidth Parameter](https://reader036.fdocuments.net/reader036/viewer/2022083006/568139f0550346895da1a8e1/html5/thumbnails/5.jpg)
Magnus Westerlund
A Solution
• Define a transport independent version of the AS bandwidth modifier (TIAS), i.e. only payload bitrate.
• Define attributes for maximum packet rate (a=maxprate)• The maximum bandwidth over a link can then be
calculated as: BW = TIAS + maxprate*size(IP/UDP/RTP)• Define default behavior for RTCP that will give all
participants equal send rate, although not equal bit rate.
![Page 6: Transport Independent SDP Bandwidth Parameter](https://reader036.fdocuments.net/reader036/viewer/2022083006/568139f0550346895da1a8e1/html5/thumbnails/6.jpg)
Magnus Westerlund
The Way Forward
• Intended as a simple and quick fix that can be used until SDP-NG becomes available.
• SDP-NG must consider the problems in more detail.• Is needed for different services that will run over NAT-PTs.
For example 3GPP’s Packet-based Streaming Service needs accurate bandwidth modifiers for radio resource allocation and to determine if a session can be supported.
• To meet the 3GPP deadlines, an RFC is needed June 2003. Target: WG Last call in January.
• New version before Christmas.
![Page 7: Transport Independent SDP Bandwidth Parameter](https://reader036.fdocuments.net/reader036/viewer/2022083006/568139f0550346895da1a8e1/html5/thumbnails/7.jpg)
Magnus Westerlund
Open Issues
• May this work become a MMUSIC Work Group Item?• Is there any need at all for average packet rates?• Usage of TIAS on session level?• Is the RTCP solution satisfactory?• Influence the draft-ietf-avt-rtcp-bw-05.txt?• Protocol Interactions need review!