Traceability & Manufacturing MonitoringGraphicLib)/Screw_Driving... · on a Universal custom...
-
Upload
vuongkhanh -
Category
Documents
-
view
217 -
download
0
Transcript of Traceability & Manufacturing MonitoringGraphicLib)/Screw_Driving... · on a Universal custom...
-
090303 ofa division configuration 1
Multi-ProcessOur customers have used the Polaris for more than a single process machine in manyapplications, the following pages show a few of the applications where the combination of Dispensing and pick and place processes. These customers realized the value of protecting their investment, and minimizing the front end costs associated with multiplemachines in a single line to accomplish what this machine can. Some of these machines have been converted to other processes as of this writing, andthose customers have reaped the benefits of protecting the automation investment. Theaverage cost to convert a single cell from one process to another varies, but it is alwaysless expensive than an additional capital investment. As our economy continues to wain, Universal's Polaris customers have been able toperpetuate their automation strategies without going back to the bank!
-
090303 ofa division configuration 2
Polaris Multi-Process Live demonstration of Multi-Process
Capabilities Pick and place, dispensing, vision
tolerance inspection, screw driving
Desktop Card and Pencil Holder
-
090303 ofa division configuration 3
Under Board ScrewingCustomer Application This customer application is
mounted on a Polaris Servo Gripper machine
The Screw driver is mounted under the Board handling on a single axis
The machine picks the connector, places it and holds it in place while the screwdriver secures it to the PCB
-
090303 ofa division configuration 4
Under board on Conveyor
Customer Application This customer application is mounted
on a Universal custom conveyor This is a dual pneumatic drive The conveyor locates the product,
checks for the connector presence, clamps the connector and drives two screws.
Cycle time is15 seconds for three circuits
-
090303 ofa division configuration 5
Over board on Conveyor
Customer Application This customer application is mounted
on a Flexlink custom conveyor This is a dual pneumatic drive The conveyor locates the product,
checks for the motor presence, clamps the motor and drives two screws. The screw drivers index to another set of holes and the process repeats
Cycle time is15 seconds for each motor.
Multi-Process ApplicationsPolaris Multi-ProcessUnder Board ScrewingUnder board on ConveyorOver board on Conveyor