THIRD PARTY TIE‐IN REQUEST FORM - Karve EnergyTHIRD PARTY TIE‐IN REQUEST FORM Yes Yes Yes Yes No...
Transcript of THIRD PARTY TIE‐IN REQUEST FORM - Karve EnergyTHIRD PARTY TIE‐IN REQUEST FORM Yes Yes Yes Yes No...
PART 1: PRODUCER CONTACT INFORMATION
Date:
Company Name:
Company Address incl. Postal Code:
Contact Person:
Title:
Contact: Office Cell Fax
E‐mail:
Field Foreman Name / E‐mail: E‐mail
Field Foreman Contact: Office Cell Fax
Facilities Engineering Contact: Office Cell Fax
Marketing Contact: Office Cell Fax
Production Accounting Contact: Office Cell Fax
PART 2: WELL DETAIL
Well Name:
Well UWI:
Field Name: Field Code:
Pool Name: Pool Code:
Licensee:
Well Ownership Percentages:
Company Name Working Interest %
Service(s) Required:
Other (Explain): _____________________
Take‐in‐Kind:
Construction Start Date:
Expected Production Date:
Delivery Method:
PART 3: PRODUCTION INFORMATION
Producing Zone:
Type:
Classification:
H2S Content: mol/kmol
Analysis:
Gas:
Oil:
Condensate:
Water:
THIRD PARTY TIE‐IN REQUEST FORM
YesYes
YesYes
NoNoNoNo
Gas Processing Compression
Trucking Existing Flowline New Flowline
Gas OilSweet Sour CBM
Attached to FormAttached to FormAttached to FormAttached to Form
Transportation Other
SWD Contract OpEffluent Treating Prod Accounting
Yes No ACL to Market Product
Page 1 of 2
Karve Facility or Battery Location:
THIRD PARTY TIE‐IN REQUEST FORM
PART 4: WELL PERFORMANCE
Estimated Production Rate: Gas (103m3/d) Water (m3/d)
Oil API Sulphur (%)
Well Shut‐in Pressure (kPag):
Well Flowing Pressure (kPag):
Well Flowing Temperature (oC):
PART 5: PIPELINE DESIGN
Pipeline Start Location:
Pipeline End Location:
Size (mm OD):
Wall Thickness (mm):
MOP (kPag):
Linepipe Grade:
Linepipe Category:
Pigging Facilities:
Tie‐in Detail:
PART 6: WELLSITE PRODUCTION EQUIPMENT
Design Standard:
Wellsite/Facility ESD:
Process Equipment:
Metering:
Separator:
Lineheater:
Compression:
Dehydration:
Liquids Handling:
Water:
Condensate:
Materials:
Temperature Rating
Metering (Gas):
Meter Run Size (mm OD):
Fuel Gas Source:
Cathodic Protection:
Insulation Kit at Tie‐in Point:
Insulation Kit at Wellsite:
Cathodic Protection required from __________
Annual Pipeline Review / Assessment to be
completed by __________
Type of Meter: ___________________________________________
YesYesYesYesYes
NoNoNoNoNo
YesYesYes
NoNoNo
290 359Category 1YesAbove Ground Tie-in Below Ground Hot TapBelow Ground Cold Cut
Category 2No
CSA Z662Yes
B31.3No
TankTank
PipelinePipeline
Low Temperature
Well
Standard Temperature
Yes
Yes
No
No
Other Source
Page 2 of 2
Email form to: [email protected]