Thermally Responsive Building Materials and Technologies
Transcript of Thermally Responsive Building Materials and Technologies
![Page 1: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/1.jpg)
Thermally Responsive Building Materials and Technologies
D E V S Kiran Kumar
6th GRIHA Regional Conference
3-4 February 2015
TERI, Bangalore
![Page 2: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/2.jpg)
Energy Efficiency in Buildings
Conventional Building Low Energy Building
100
30
![Page 3: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/3.jpg)
Thermal Performance of Building Materials
40°C
36°C 33°C
27°C
• Indigenous materials
• Thermally appropriate materials
![Page 4: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/4.jpg)
Thermal Performance of Building Materials
Sue Roaf et al, 2001, Ecohouse-A design guide
![Page 5: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/5.jpg)
Thermal Performance of Building Materials
Randall McMullan 1983, Environmental Science in Building
![Page 6: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/6.jpg)
Phase Change Materials
Image Courtesy: Insulla
![Page 7: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/7.jpg)
Thermal Performance of Building Materials
• Mineral Characteristics • Heat capacity and
thermal conductivity
• Density/Porosity • Thickness
• Surface Texture • Reflectivity
N C Balaji et al, 2014, Discerning heat transfer in building materials; Jacqueline D. Spears & Dean Zollman, 1990, Fascination of Physics
![Page 8: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/8.jpg)
Thermal Performance of Building Materials
Roof Coatings-
Cenospheres
Roof Coatings-
Mica particles
Glazing-Nano
Louvers
Bhavani Balakrishna, 2011, Ceramic Insulation Paints: The need for Insulating construction materials, Gu¨ nther Walze et al, 2005, Combination of microstructures and optically functional coatings for solar control glazing
![Page 9: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/9.jpg)
The Issue and Solution
Major source of heat gain by the roof is absorbed solar radiation
Reflect incident solar radiation using high albedo surface
Heat gain through roof elevates ceiling surface temperature and
causes radiant heat load inside the building
Store absorbed radiant heat for
longer time by using heavier materials
When hot ambient air touches these surfaces, the inside air might
become hotter than outside
Make indoor surface temperatures near
to air temperatures, reduce heat load
![Page 10: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/10.jpg)
Hypothesis
• Maintaining the surface temperature equal to or lower than the air temperature by reflecting back the solar radiation and further using minimal heat insulation performs better than a highly insulated surface.
• Light and highly resistive materials (low heat capacity) have a minor impact in un- conditioned buildings located in hot dry climates when surfaces are either reflective or shaded
![Page 11: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/11.jpg)
Experimental Setup
Roof 1_ Cement Tile Roof 2_ XPS
Roof 3_ POP False Ceiling
![Page 12: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/12.jpg)
Experimental Setup
Ambient Air Sensor
Overdeck surface probe
Underdeck surface probe
Indoor air sensor
Datalogger
![Page 13: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/13.jpg)
Performance Indices
Theoretical
U-Value
Admittance
Experimental
Time lag
Decrement Factor
Comfort
Building Index
Discomfort Degree Hour
![Page 14: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/14.jpg)
Air Temperature
![Page 15: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/15.jpg)
Surface Temperature
![Page 16: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/16.jpg)
Surface Temperature
![Page 17: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/17.jpg)
Performance Indices
![Page 18: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/18.jpg)
Performance Indices
![Page 19: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/19.jpg)
Performance Indices
![Page 20: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/20.jpg)
Performance Indices
![Page 21: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/21.jpg)
Physical Structure
Cool mortar -Model 1
Conductivity 0.451
Specific heat 0.87
Density 1850
Volumetric Heat Capacity 1925
Extruded Polystyrene- Model 2
Conductivity 0.028
Specific heat 1.25
Density 34
Volumetric Heat Capacity 1290
POP false ceiling board- Model3
Conductivity 0.499
Specific heat 0.2
Density 1080
Volumetric Specific heat 764
![Page 22: Thermally Responsive Building Materials and Technologies](https://reader030.fdocuments.net/reader030/viewer/2022012416/617173bd7b64417d644c65ff/html5/thumbnails/22.jpg)
Conclusions
• Innovative indigenous materials like cement tile performs better in 24-hour occupied residential buildings in hot and dry climates due to its high volumetric heat capacity.
• Indicators like Discomfort Degree Hour & heat flux clearly show better thermal performance by the cement tile
• There is a need for a more specific and climate wise thermal performance indices for the codes like Energy Conservation Building Code (ECBC) of India