The South African Journal of Science - iThenticate
-
Upload
academy-of-science-of-south-africa -
Category
Science
-
view
129 -
download
5
Transcript of The South African Journal of Science - iThenticate
The South African Journal of Science - iThenticate
11 August 2016 11:00
Nadine WubbelingOnline Publishing Administrator
iThenticate and Scholar One
• Integrated within the Scholar One workflow
iThenticate and Scholar One: integration
iThenticate and Scholar One: integration
The check
The iThenticate dashboard
The match overview
The match breakdown
The sources
iThenticate PDF
The percentages
SAJS: the percentages
• Set up own internal guidelines by using CrossCheck and iThenticate recommendations
• Important to remember that: – the percentage level of each similarity report can contain several individual
sources – these individual sources have their own similarity percentage that is
combined into the full report’s similarity index • You should look closer if:
– a substantial amount of text in the paper has been duplicated from an original source
– if the text from the original source is not cited in the paper – an individual source word count is higher than 100 words
Overall similarity report
• Less than 10%Not likely to be an issue–Sporadic matching text or commonly used phrases–Single sources normally only yield 1-3% similarity–Check for high individual counts–Briefly scan the paper for large chunks of text and whether this source is cited or not
• 10-50%Possible issue (review more thoroughly)–May contain portions of copied text that are of some concern, but this depends on the percentage of similarity in the individual sources–Opening and briefly reviewing these reports can ensure that no individual source has more than 10% similarity
Overall similarity report
• Higher than 50% Probable issue (review carefully)–At this level, the report percentage is automatically highlighted by CrossCheck in orange–These reports require a more careful review–There is likely to be a high percentage of similarity to one or more source
Overall similarity report
Individual sources• Less than 3% match
– Occurs with small groups of similar words or a few short phrases; there is little need to review these sources
• 4-7% match– These matches can be single
sentences or a small paragraph– One source at this level may not be
an issue, but several sources at this percentage level could signify an overall problem with the submission
• 8-15% match– A source in this percentage range
usually involves a few matching paragraphs
– Similarity at this level could indicate reused material
• 15-25% match– This level of similarity in a single
source likely involves as much as one full page of matching material, depending on the size of the submission
– It is important to check matches carefully against the source
• More than 25% match– This level of similarity from a
single source should raise serious concerns about inappropriate reuse, and should be checked very carefully
Individual sources
Other factors• False Alarms
– A false alarm paper yields an overall high percentage but there are many different sources which all yield 5% or less. These papers need only a brief review
• Hidden Problems – Papers that look acceptable on the surface but show possible plagiarism upon review of the
report. They generally have a low overall similarity percentage but yield a high percentage from a single source.
– Example:
• Methods– Sometimes methods cannot be phrased differently than the original source. This can increase
the similarity percentage– In these cases make sure the original source is cited. Look at your policies more closely
regarding original work
12% OVERALL SIMILARITY
One source = 1% of similar textSecond source = 11% of similar
text
SAJS Plagiarism policy:http://sajs.co.za/plagiarism-policy
Plagiarism in South African management journals:http://sajs.co.za/plagiarism-south-african-management-journals/adele-thomas-gideon-p-de-bruin
Installing the iThenticate plugin in OJS
1.Download OJS iThenticate Plugin from: https://pkp.sfu.ca/support/forum/viewtopic.php?t=7041 2.Login as System Admin/Journal Manager for the OJS installation you are working with.3.At Journal Management, click on System Plugins.4.Click on Install a New Plugin.5.Install the iThenticate plugin for OJS by following the wizard.6.OJS will add the plugin to Generic Plugins.
Activating the iThenticate plugin in OJS
1.Under Generic Plugins, scroll down to iThenticate Plagiarism Detector Plugin.2.Then click on Enable.
3.OJS will confirm that the plugin has been enabled:
Using the iThenticate plugin in OJS
1.Once the plugin in OJS has been enabled, OJS will automatically send all new articles submitted for a specific journal to the folder created for the journal in iThenticate2.If you prefer only selected manuscripts to be checked for plagiarism, Disable the plugin, and manually submit an article to be checked for similarities
Folder for SAJSM with 5 articles checked
Click on article to view report
View report in iThenticate & print to pdf
Article title blinded
Questions