TestBells 642-902 Exam
-
Upload
testbells-testbells -
Category
Documents
-
view
253 -
download
1
description
Transcript of TestBells 642-902 Exam
Cisco 642-902 Exam Demo
Implementing Cisco IP Routing (ROUTE)
For Complete real exam in just $39 go on http://www.testbells.com/642-902.html
QUESTION NO: 297
To configure 6to4 on a dual-stack edge router. Which three of the following are valid in 6to4
Tunneling configuration? (Choose three)
A. IPv4 Tunnel IP address
B. Tunnel mode (6to4)
C. Tunnel Keepalives
D. IPv4 Tunnel Destination
E. IPv4 Tunnel Source.
F. 6to4 IPv6 address (within 2002 /16)
Answer: B,E,F
QUESTION NO: 298
In EIGRP, when the IP default-network command is configured on a router, what is generated in
the router’s configuration?
A. A static route
B. A directly connected route
C. An EIGRP route
D. A default route
Answer: D
QUESTION NO: 299
Refer to the exhibit.
OSPF is running throughout the network and RIP is being redistributed into OSPF in R2. You
want to minimize the propagation of LSAs into and out of Area 1.
Which OSPF feature would be best to achieve this goal?
A. stub
B. totally stubby
C. NSSA
D. totally NSSA
Answer: D
QUESTION NO: 300
A problem was reported that the 10.10.10.0/24 prefix was not injected into the local BGP table
on RouterA. The following information is available from RouterA:
configuration:
router bgp 65001
network 10.0.0.0
neighbor 172.16.1.1 remote-as 65002
no auto-summary
routing table information:
show ip route | include 10
O 10.10.10.0/24 [110/11] via 192.168.1.1, 2d00h, Ethernet0/0
Why is this prefix not in the local BGP table?
A. This route is not a BGP learned route.
B. The network command is wrong.
C. The 172.16.1.1 neighbor is down.
D. The prefix 10.10.10.0/24 is not a 'connected' route.
Answer: B
QUESTION NO: 301
Refer to the exhibit.
Which router configuration command can be given that will restrict router RTB from sharing its
routing information with router RTA?
A. the eigrp stub command on router RTA
B. the eigrp stub command on router RTB
C. the eigrp stub connected command on router RTA
D. the eigrp stub connected command on router RTB
E. the eigrp stub receive-only command on router RTA
F. the eigrp stub receive-only command on router RTB
Answer: F
QUESTION NO: 302
Given the above output, which statement is true?
A. 192.168.1.0 is a static route.
B. 192.168.1.0 is a summarized route.
C. 192.168.1.0 is a redistributed route into EIGRP.
D. 192.168.1.0 is equal path load balancing with 172.16.1.0.
Answer: C
QUESTION NO: 303
Which two types of routes will be advertised with the EIGRP configuration as shown?
(Choose two.)
router eigrp 100
eigrp stub
A. static
B. receive-only
C. summary
D. stub
E. connected
F. dynamic
Answer: C,E
QUESTION NO: 304
Refer to the exhibit.
What happens when the router stops receiving advertisements for the 10.1.2.0/24 network?
A. The summary route will be removed from the table.
B. The summary route will remain in the table.
C. The more specific routes will be advertised from the table.
D. 10.1.2.0/24 will still be advertised but packets destined for it will be dropped when they
reach this router.
Answer: B
QUESTION NO: 305
Refer to the exhibit. On all routers in the network, EIGRP has been configured for load
balancing across the three links. However, traffic destined for Network B from R1 is only load
balanced over paths R1-R2-R5 and R1-R3-R5. What is the cause of the problem?
A. EIGRP will not select more than two links for unequal cost path load balancing.
B. Because the path has a different link type, EIGRP will not select path R1-R4-R5 for load
balancing.
C. Because Router R4 is not a feasible successor, EIGRP will not select path R1-R4-R5 for load
balancing.
D. EIGRP will not select path R1-R4-R5 for load balancing unless the value of the variance
parameter is increased.
Answer: C
QUESTION NO: 306
Identify three characteristics of EIGRP feasible successors? (Choose three.)
A. A feasible successor is selected by comparing the advertised distance of a non-successor
route to the feasible distance of the best route.
B. If the advertised distance of the non-successor route is less than the feasible distance of best
route, then that route is identified as a feasible successor.
C. If the successor becomes unavailable, then the feasible successor can be used immediately
without recalculating for a lost route.
D. The feasible successor can be found in the routing table.
E. Traffic will be load balanced between feasible successors with the same advertised distance.
Answer: A,B,C
For Complete real exam in just $39 go on http://www.testbells.com/642-902.html