www.raisecom.com /

www.raisecom.com

TDM over IP

International Department

2010-7-15

www.raisecom.com /

RAISECOM TDM over IP

TDMoIP Specification

4 E1/T1 TDMoIP product

1 E1/T1 TDMoIP product

How to config

Nview NNM V5 GUI

www.raisecom.com /

TDMoIP product family

1 E1T1 4 E1T1 16 E1T1 E1T1 capacity

Remote

Central

RC1201 2FEE1T1 RC1201-2FEE1T1

RC1201 2GESTM1 RC1201-2GESTM1

RC1201 4FE4E1T1 RC1201-4FE4E1T1 RC1201 GE16E1T1 RC1201-GE16E1T1

RC1201 2FEV35 RC1201-2FEV35

STM1/OC-3

www.raisecom.com /

TDMoIP specification

• Support SAToP, CESoPSN, TDMoIP, and HDLC

• PSN type: MPLS, IP, and Ethernet

• Maximum bundle number: 64

• E1/T1 clock mode: internal, loopback, adaptive, external, and common

• Compliant to G.823, G.824

• Unbalanced/balanced E1, balanced T1

• Configurable jitter buffer

• Compliant to G.8261, support 2% scrambling and packet loss

• Configurable Ethernet transmission unit

www.raisecom.com /

Ethernet specification

• Maximum transmission unit: 1632 bytes

• Rate limiting per port, 62k – 1000M non-linear

• Broadcast, multicast and DLF storm control per port

• 4K active 802.1Q VLAN, double tagging (Q-in-Q)

• 802.3x and back pressure flow control

• 8K MAC address table entry, 30 static MAC addresses

• Configurable MAC address learning per port

• Configurable MAC aging time 0 – 3825s

• QoS support, 4 output queues

• Port isolation

• BPDU, LACP and 802.1x transparent relay

• Ethernet port loopback detection

www.raisecom.com /

E1 specification

• Compliant to G.703, G.704, G.706, G.732 and G.823

• Connector type: BNC for unbalanced, RJ45 for balanced

• Impedance: 75 Ohm unbalanced, 120 Ohm balanced

• Data rate: 2.048Mbps

• Line code: HDB3

• Frame structure: unframed, framed, multiframe, with or without CRC4

• Clock compliant to G.823

• Jitter compliant to G.823

• Electrical characteristic: G.703

• Transform characteristic: G.823

• Unbalanced/balanced auto sensing

www.raisecom.com /

T1 specification

• Compliant to ANSI T1.403, AT&T TR-62411, ITU-T G.703, G.704 and G.824

• Connector type: RJ45 for balanced

• Impedance: 100 Ohm balanced

• Data rate: 1.544 Mbps

• Line code: B8ZS, AMI, B7ZS

• Frame structure: unframed, SF, and ESF

• Clock compliant to G.824

• Jitter compliant to AT&T TR-62411, G.824

• Electrical characteristic: G.704

• Transform characteristic: G.824

www.raisecom.com /

Basic clocking mode

Internal timing mode

Loopback timing mode

www.raisecom.com /

Basic clocking mode (cont.)

Adaptive timing mode

External timing mode

www.raisecom.com /

RC1201-4FE4E1T1 front panel

Power

supply

module

Gigabit

Ethernet

interface

Fast

Ethernet

interfaces

SNMP

port

Console

port

•1U 19’ standalone in metal enclosure, single power supply, less than 13W •Transmit 4 x E1/T1 services over PSN network (IP, MPLS, Ethernet) •4 x FE and 1 x GE (SFP) for local and line Ethernet connection •CLI/SNMP management

www.raisecom.com /

RC1201-4FE4E1T1 rear panel

Expansion

slot

4 x E1/T1

interfaces

Unbalanced

BNC

Balanced

RJ45

•Unbalanced and balanced E1 interfaces •Balanced T1 interfaces •Expansion card for E1/T1 clock input/output

www.raisecom.com /

Expansion cards

RC1201-SC-SYNC

E1/T1/2MHz clock input/output, CC3 connector

www.raisecom.com /

RC1201-2FEE1T1/V35 front panel

•1U 19’ standalone in metal enclosure, single power supply, less than 13W •Transmit 1 x E1/T1 or V.35 services over PSN network (IP, MPLS, Ethernet) •2 x FE and 1 x GE (SFP) for local and line Ethernet connection •CLI/SNMP management

Power

supply

module

Gigabit

Ethernet

interface

Fast

Ethernet

interfaces

SNMP

port

Console

port

www.raisecom.com /

RC1201-2FEE1T1 rear panel

•Unbalanced and balanced E1 interfaces •Balanced T1 interfaces

Unbalanced

BNC Balanced

RJ45

1 x E1/T1

interfaces

1 x V.35

interfaces •V.35 interface

www.raisecom.com /

Application ••Point to mutiPoint to muti--point transmission application based on Packet point transmission application based on Packet Switched Network Switched Network

www.raisecom.com /

Application (cont.)

••Transmission based on Packet Switching Networks for voice Transmission based on Packet Switching Networks for voice and Ethernet multiplexerand Ethernet multiplexer

••Point to point transmission application based on Packet Point to point transmission application based on Packet Switched Network Switched Network

www.raisecom.com /

Application (cont.)

••Serial data services moved to Packet Switched NetworksSerial data services moved to Packet Switched Networks

www.raisecom.com /

RAISECOM TDM over IP

TDMoIP Specification

4 E1T1 TDMoIP product

1 E1T1 TDMoIP product

How to config

Nview NNM V5 GUI

www.raisecom.com /

Device basic configuration current running configuration of this nodes:

snmp-server community public ro //SNMP MGT configuration

snmp-server community private rw

……

device description RC1201-4FE4E1T1-Raisecom^Technology^Co.,^Ltd.

double-tagging tpid 9100

no use-core-tag

trunk disable

mac-address-table aging-time 0

mac-address-table learning disable

qos

qos queue fix-priority

qos map cos-queue 4 4 2 2 1 1 4 4

ip-address 10.10.10.4 255.0.0.0 //IP address of the device

device clock master osc

device clock fallback osc

!post-config commands:

exit

clock timezone + 8 0

www.raisecom.com /

E1/T1 interface configuration

Interface ID: 1

Interface Descr: tdm port-1 //description

PortSendcode: e1HDB3 //line code

Interface type: balance //interface connector type

Ds1 type: E1 //interface type <E1/T1>

Loopback config: no Loopback

Frame mode config: unframed //frame mode for E1/T1

CRC4 config: enable //E1 CRC4 status

T1 Signaling mode config: none //T1 signaling

DS0 idle code: 255 //TDM port unuse ds0 idle code

Tx Clock Source Config: recovery clock //transmit clock source

Clock Recover Bundle: 1 //bundle id used for adaptive clock

LineStatus: LOS //link status

www.raisecom.com /

Bundle configuration Raisecom(config-bundle/0/1)# sho interface

Bundle ID: 1 //bundle ID

Bundle Descr: bundle-1 //description

Bundle Connection Config: enable //connection status

Destination Bundle ID: 1 //destination bundle ID

Jitter Buffer: 8 //jitter buffer size

Bundle Payload Type: SAToP //bundle payload type

SAToP Frame Length: 32 //payload length in the frame

TDM Port Index: 1 //E1/T1 port number

Bundle PSN Type: UDP/IP //PSN type

IP Version: IPV4 //IP version

Destination IP Address: 10.10.10.5 //destination IP address

IP TOS: 0 //IP ToS

IP TTL: 255 //IP time to live

Next Hop Address Type: IP //next hop address type

Next Hop Address: 10.10.10.5 //next hop address

Tag Vlan Mode: Untag //VLAN mode

Bundle Status: Normal //current bundle status

Bundle Statistic: //bundle statistics

Bundle Transmit Packet: 68083175

Bundle Receive Packet: 68084355

Bundle Discard Packet: 0

www.raisecom.com /

Bundle info.

Raisecom(config-bundle/0/1)# show bundle info

Jitter Buffer Underflow: ...(7)

Jitter Buffer Overflow: ...(0)

Max jitter buffer level(ms): ...(252.33)

Min jitter buffer level(ms): ...(0.00)

Max jitter buffer deviation(ms): ...(250.00) //statistics JB in last time

quantum

Packet per second: ...(426) //Frame per second

Required IP bandwidth(bps): ...(2167488) //calculate IP BW of Bundle

Required Ethernet bandwidth(bps): ...(2215200) //calculate ETH BW of

Bundle

Packetization delay(ms): ...(2.34) //packet creation time

End to End delay(ms): ...(253.34) //single trip delay

www.raisecom.com /

Ethernet interface configuration Interface ID :1

Descr :Slot 0 eth interface 1

Interface type :electrical

Port enable(command) :enable

Port enable status :enable

AutoMdi config :enable

AutoMdi status :enable

Link status :cross

Autonego config :enable

Autonego status :enable

Duplex config :full-duplex

Duplex config status :half-duplex

Duplex status :half-duplex

Speed config status :10M

Speed status :10M

Flow control config:off

Flow control status:off

Link :linkdown

RJ45 interface

Interface ID :1

Descr :Slot 0 fx-ge interface 1

Interface type :optical

Port enable(command) :enable

Port enable status :enable

Flow control config:off

Flow control status:off

Als config:enable

SFP fiber interface

www.raisecom.com /

SNMP MGT configuration

Interface:snmp

Administration Status : up Operation Status : down //status

Description: SNMP-MGT-Interface //description

Internet address: 192.168.6.99 Netmask: 255.255.255.0 //IP address

Ethernet address: 00:01:02:03:04:05 //MAC address

Duplex:full-duplex Speed:100baseT

Autonegotiation:enable

www.raisecom.com /

In-band MGT configuration

interface vcc

ip address 192.168.12.1 255.255.255.0 //IP address of VCC

vlan id 101 //VLAN ID of VCC

www.raisecom.com /

RAISECOM TDM over IP

TDMoIP Specification

4 E1T1 TDMoIP product

1 E1T1 TDMoIP product

How to config

Nview NNM V5 GUI

www.raisecom.com /

Nview NNM V5 GUI

Topology Management function of TMN

www.raisecom.com /

Nview NNM V5 GUI

Initiated device management view

www.raisecom.com /

Nview NNM V5 GUI

Equipment Snapshot

www.raisecom.com /

Nview NNM V5 GUI

TDM

interface

configuration

www.raisecom.com /

Nview NNM V5 GUI

FE port

Configuration

& SFP interface

management

www.raisecom.com /

Nview NNM V5 GUI

Alarm management

www.raisecom.com / www.raisecom.com