Tablet feeding machine copy
-
Upload
efronlianu -
Category
Engineering
-
view
62 -
download
2
Transcript of Tablet feeding machine copy
TABLET FEEDING MACHINE
MAHINDRA BIN ABD MIDMOHD ARIF FARHAN BIN AZHAMOHD ASSRY BIN MOHD RADZUAN
INTRODUCTION Tablet feeding machine is used to filling tablet into
bottle and sealed it. This machine operate using 415 V/AC and pneumatic
system. This machine consist of conveyor and 2 module :
i. Module 1 : feeding process
ii. Module 2 : sealing process
MODULE 1 : FEEDING PROCESS This module consists of 2 part :
Vibrator : to transfer tablet from tank to spinning plate
Spinning plate : spread the tablet to be fill into bottle
MODULE 2 : SEALING PROCESS At this modul, the sealing process done by single
acting cylinder. the piston will move and suck the bottle cap. Then the
cylinder will move to the top of the bottle and push the cap to seal it.
• input list and output list for the tablet feeding machine
Input output
sensors
i. Proximity sensor
ii. Photoelectric sensor (through beam)
iii. Magnetic sensor limit switch Push button
Contactor valves
GENERAL OPERATING : Start the conveyor by pressing the ‘conveyor on’ .
Check the direction of the conveyor rotation wheather it is correct or not. Inverse the phase if the rotation is wrong.
Start the operation by turning the switch to ‘on’. The green indicator lamp for each module should light up.
This is the picture of the control system for the feeding tablet machine :
Place the bottle and snap cap on the pallets then put pallets on the conveyor. (The bottle should be infront of snap cap carries)
The pallet will move and through the limit switch (S4) and stop for the feeding process at module 1.
Once the feeding process is done, the conveyor will move until the bottle at the pallet touch the limit switch (S11) and stop for the sealing process.
Sealing process will be done at module 2. once it done, the conveyor will move.
To stop the machine by turning the switch to ‘off’ then stop the conveyor by pressing the ‘conveyor stop’ button.