SYMONITE ALUCOLUX CLADDING (DAB) SYSTEM TYPICAL …

9.02.0 TYPICAL HORIZONTAL JOINT ON RAB
2.1 TYPICAL HORIZONTAL JOINT ON BUILDING PAPER
3.1.0 HEAD DETAIL - FAIRVIEW RESIDENTIAL JOINERY
3.1.1 SILL DETAIL - FAIRVIEW RESIDENTIAL JOINERY
3.1.2 JAMB DETAIL - FAIRVIEW RESIDENTIAL JOINERY
3.2.0 HEAD DETAIL - FAIRVIEW COMMERCIAL JOINERY
3.2.1 SILL DETAIL - FAIRVIEW COMMERCIAL JOINERY
3.2.2 JAMB DETAIL - FAIRVIEW COMMERCIAL JOINERY
4.0 FASCIA DETAIL - SOFFIT BY OTHERS
4.2.0 FASCIA TO SOFFIT
4.3.0 DRIP EDGE DETAIL
5.0 BASE DETAIL 1
5.2 TYPICAL UPSTAND DETAIL
6.1 FIBRE CEMENT VERTICAL INTERNAL CORNER
6.2 VERTICAL PROFILED METAL INTERNAL CORNER
6.3 HORIZONTAL PROFILED METAL INTERNAL CORNER
7.0 TYPICAL WALL TO SOFFIT JUNCTION 1
7.2.0 TYPICAL WALL TO RAKING SOFFIT JUNCTION 1
7.2.1 TYPICAL WALL TO RAKING SOFFIT JUNCTION 2
7.3 WALL TO SOFFIT JUNCTION & DOWNPIPE PENETRATION
8.0 PRECAST CONCRETE WALL JUNCTION 1
8.1 PRECAST CONCRETE WALL JUNCTION 2
9.0 VERTICAL PROFILED METAL JUNCTION
TYPICAL DETAILS
0.0SYMONITE TECHNICAL DRAWINGS 2021 ã SYMONITE PANELS LIMITED Technical specification subject to change without prior notice
General notes:
1. Consider 'hatched' areas as outside of Symonite scope and indicative only.
2. All commercial detailing shows rigid air barrier (RAB) as is common practice.
3. All residential detailing shows building wrap as is common practice.
Framing note: Timber framing by others is to be at 600 centres max for both studs &
nogs. This may be required at closer centers subject to engineering requirements.
Rigid air barrier note: As per Symonite BRANZ Appraisal #528 section 12.2 "A
building with exposure to wind on any part of its facade above 1.55 kPa ULS must
use a RAB as backing for the cavity". It is the building designers responsibility to
determine wind loading on the building and incorporate RAB into the detailing as
required to the specifications of the RAB manufacturer.
Cavity Battens are not required with the Symonite cladding system as a cavity is
formed between the fixing angles and structure with high impact plastic packers ("H"
packers). Minimum cavity depth is 40mm from structure to outer face of panel
although experience shows the cavity is normally 50mm or more. Any instance
where cavity is pushed beyond 60mm may require the installation of 20mm cavity
battens by others.
SYMONITE TECHNICAL DRAWINGS 2021 ã SYMONITE PANELS LIMITED Technical specification subject to change without prior notice
1.0
NOTE: TIMBER FRAMING BY OTHERS TO BE AT 600 CTRS MAX FOR BOTH STUDS & NOGS. MAY BE REQUIRED AT CLOSER CENTERS SUBJECT TO ENGINEERING REQUIREMENTS
1 - 1:2 @ A4
60 -7
0 VA
R IE
SPECIFIED RAB BOARD ON TIMBER FRAMING BY OTHERS
HIGH IMPACT PACKERS BY SYMONITE (INDEPENDENTLY FIXED WHEN MORE THAN 2 PACKERS ARE USED)
SYMONITE ALUCOLUX CLADDING (DAB) SYSTEM
1 - 1:2 @ A4
1.1
15
SEALANT ON 20MM PEF ROD BY SYMONITE
BUILDING PAPER ON TIMBER FRAMING BY OTHERS
90mm WIDE 0.9mm ALI. UNDERTRAY BY SYMONITE
NOTE: IF IT'S O PAPER IT SHOULD BE ROUT AND RETURN SYSTEM
1 - 1:2 @ A4
ALUCOLUX BY SYMONITE
(INDEPENDENTLY FIXED WHEN MORE THAN 2 PACKERS ARE
USED)
BY OTHERS
2.0
15
2.1
1 - 1:2 @ A4
(INDEPENDENTLY FIXED WHEN MORE THAN 2 PACKERS ARE USED)
ALI. UNDERTRAY BY SYMONITE
BY OTHERS
(DAB) ALI. FIXING EXTRUSIONS BY SYMONITE
NOTE: IF IT'S O PAPER IT SHOULD BE ROUT AND RETURN SYSTEM
HEAD DETAIL - FAIRVIEW RESIDENTIAL JOINERY (SECTION) 1:2 @ A4-
1
3.1.0
1000mm2/lm BY SYMONITE
FLASHING TAPE, PACKING & AIR SEAL BY OTHERS
MIN. PANEL OVERLAP TO JOINERY
60-70 VARIES
SIMILAR BY SYMONITE
50mm FROM PANEL JOINTS BY SYMONITE
PROPRIETARY JOINERY BY FAIRVIEW
(INDEPENDENTLY FIXED WHEN MORE THAN 2
PACKERS ARE USED)
BY OTHERS
AutoCAD SHX Text
2
FLASHING TAPE, PACKING & AIR SEAL BY OTHERS
0.9mm ALI. BACKFOLD SUPPORT BY SYMONITE
FACTORY FITTED CLEATS AT PANEL FOLDS
3.1.1
IMPORTANT: ENSURE 20MM MIN CLEARANCE FROM INSIDE OF SILL TRAY TO FLASHING TAPE, FOR PANEL UPSTAND
PROPRIETARY JOINERY BY FAIRVIEW
PACKERS ARE USED)
AutoCAD SHX Text
JAMB DETAIL - FAIRVIEW RESIDENTIAL JOINERY (PLAN) 1:2 @ A4-
1
3.1.2
BY SYMONITE
FLASHING TAPE, PACKING & AIR SEAL
BY OTHERS
60 -7
0 VA
R IE
BY OTHERS
20 MIN.
AutoCAD SHX Text
20 MIN.
60-70 VARIES
ALL BY OTHERS
FRAMING BY OTHERS
BY OTHERS
VENT SLOTS OR HOLES TO ALLOW A MINIMUM
PROPRIETARY JOINERY BY
12
SIMILAR BY SYMONITE
50mm FROM PANEL JOINTS BY SYMONITE
AutoCAD SHX Text
TYPICAL FAIRVIEW COMMERCIAL SILL DETAIL (SECTION)
IMPORTANT: ENSURE 20MM MIN CLEARANCE FROM INSIDE OF SILL TRAY TO FLASHING TAPE, FOR PANEL UPSTAND
3.2.1
12
BY SYMONITE
ALL BY OTHERS
PACKERS ARE USED)
FRAMING BY OTHERS
10° FALL
AutoCAD SHX Text
3.2.2
60 -7
0 VA
R IE
15
BY SYMONITE
PROPRIETARY JOINERY BY ALTUS
SPECIFIED RAB BOARD OR BUILDING PAPER ON TIMBER FRAMING BY OTHERS
33
BY OTHERS
AutoCAD SHX Text
BY SYMONITE
SOFFIT BY OTHERS
1
4.0
BY OTHERS
PACKERS ARE USED)
ALI. FIXING ANGLE TO ENGINEER'S
SPECIFICATIONS BY SYMONITE
4.2.0
1
MINIMUM 1000mm2/lm BY SYMONITE
BY SYMONITE AS REQUIRED
BY OTHERS
PACKERS ARE USED)
(DAB) ALI. FIXING EXTRUSIONS BY SYMONITE
4.3.0
1
(DAB) ALI. FIXING EXTRUSIONS & SEALANT ON 20MM PEF ROD BY SYMONITE
FACTORY FITTED CLEATS AT PANEL FOLDS
BY SYMONITE
BY OTHERS
PACKERS ARE USED)
OPEN FLUSH SOFFIT JOINT (SECTION) 1:2 @ A4-
1
BY SYMONITE
15
BY OTHERS
PACKERS ARE USED)
BASE DETAIL 1 (SECTION) 1:2 @ A4-
1
5.0
PANEL ENDS BY SYMONITE
BY OTHERS
SEALANT BY SYMONITE
A - 100mm For Exterior Paving B - 175mm For Unpaved Ground C - 50mm For Garage Floor
CONCRETE SLAB BY OTHERS
BY SYMONITE
BY SYMONITE
BY SYMONITE
60-70 VARIES
20 MIN
SYMONITE TECHNICAL DRAWINGS 2021: ã SYMONITE PANELS LIMITED Technical specification subject to change without prior notice
SYMONITE ALUCOLUX CLADDING SYSTEM
15
BY SYMONITE
USED)
OVER TIMBER FRAMING BY OTHERS
(DAB) ALI. FIXING EXTRUSIONS & SEALANT ON PEF ROD BY SYMONITE
12
MINIMUM 1000mm²/lm BY SYMONITE
60-70 VARIES
61 -7
0 VA
R IE
20MM MIN CLEARANCE AT SILL TRAY FOR PANEL UPSTAND
60MM MIN CLEARANCE FROM BOTTOM OF SILL TRAY LEG TO FRAMING
BELOW
0.9MM ALI. BACKFOLD SUPPORT BY SYMONITE
PANEL SEALED TO SILL TRAY BY SYMONITE
5-8MM MIN VENT GAP
5.2
FACTORY FITTED CLEATS AT PANEL
FOLDS BY SYMONITE
UNDERFLASHING @ PANEL JOINTS
ON 20MM PEF ROD BY SYMONITE
5.3
1
Ø8mm DRAINHOLES @ 50mm FROM PANEL
ENDS BY SYMONITE
FRAMING BY OTHERS
6.0.0
INSTALLATION CONSTRAINTS ALLOW)
USED)
TIMBER FRAMING BY OTHERS
TYPICAL VERTICAL INTERNAL CORNER (PLAN) 1:2 @ A4-
1
(INDEPENDENTLY FIXED WHEN MORE THAN 2 PACKERS ARE USED)
SPECIFIED RAB BOARD OR BUILDING PAPER ON TIMBER FRAMING
BY OTHERS
FIBRE CEMENT SHEET BY OTHERS
INTERNAL CORNER BACK FLASHING
1
6.1
BY OTHERS
1
6.2
15
FLASHING BY OTHERS
(DWB) ALI. FIXING EXTRUSIONS BY SYMONITE
VERTICAL PROFILED METAL CLADDING BY OTHERS
HORIZONTAL PROFILED METAL CLADDING
CORNER FLASHING BY OTHERS
1
6.3
BY OTHERS
PACKING OR FIXING ANGLE BY SYMONITE
SOFFIT LINING BY OTHERS
1
BY OTHERS
PACKING OR FIXING ANGLE BY SYMONITE
1.2mm ALI. FLASHING BY SYMONITE
WALL TO RAKING SOFFIT JUNCTION 1 (SECTION) 1:2 @ A4-
1
7.2.0
BY OTHERS
BY OTHERS
BY SYMONITE 7
SOFFIT LINING INSTALLED BEFORE ALUCOLUX
BY OTHERS
60-70 VARIES
1
15
BY SYMONITE
BY OTHERS
7.2.1
BY SYMONITE
7.3
1
DOWNPIPE OR OVERFLOW BY OTHERS
(DAB) ALI. FIXING EXTRUSIONS & SEALANT ON 20MM PEF ROD BY SYMONITE
PENETRATION TO BE CUT AROUND ON SITE AND COVER SEALED BY SYMONITE
SOFFIT FRAMING TO BE AT 450mm CRS MAX BY OTHERS
60 -7
0 VA
R IE
S
5 5
PRECAST CONCRETE WALL JUNCTION 1 (PLAN)
1:2 @ A4- 1
8.0
SCREW FIXING WITH NYLON PLUGS BY SYMONITE
BY SYMONITE
60 -7
0 VA
R IE
SEALANT ON 20MM PEF RODS BY SYMONITE
15
(DWB) ALI. FIXING EXTRUSION & SEALANT ON 20MM PEF ROD BY SYMONITE
BACK FLASHING SEALED TO SAWCUT CHASE BY OTHERS (RECOMMENDED)
1
8.1
PRE CAST CONCRETE WALL
BY OTHERS SPECIFIED RAB BOARD OR BUILDING PAPER ON TIMBER FRAMING BY OTHERS
NOTE: CHASED FLASHING IS RECOMMENDED AT ALL VERTICAL CONCRETE JUNCTION DETAILS. IT IS THE BUILDING DESIGNER'S RESPONSIBILITY TO CHECK WITH APPLICABLE LOCAL BUILDING AUTHORITIES AS TO WHETHER THIS IS REQUIRED
61 -7
0 VA
R IE
TIMBER FRAMING BY OTHERS
COLOUR STEEL CLADDING ALL BY OTHERS
1
9.0
SPECIFIED RAB BOARD OR BUILDING PAPER ON TIMBER FRAMING BY OTHERS63-70
VARIES
15
Sheets and Views
Sheets and Views
Sheets and Views
Sheets and Views
Sheets and Views

SYMONITE ALUCOLUX CLADDING (DAB) SYSTEM TYPICAL …

Documents

Transcript of SYMONITE ALUCOLUX CLADDING (DAB) SYSTEM TYPICAL …