SELECTION ADVICE

YEAR FRONT

FORD

2006 on Ranger PJ All Models 600224

HOLDEN/ISUZU

2003 on Rodeo/Isuzu Pick up - RA Models / Colorado Diesel 60031

2003 on Rodeo/Isuzu Pick up - RA Models / Colorado V6 60031

99 to 04 Discovery Series II (Coil Models only) 60024 OMESD0291 to 99 Discovery Series I 60037 OMESD11To 5/95 Range Rover (Except Air Bag Models) 60037 OMESD11

84 on Defender & County 90, 110 & 130 60037 OMESD32

MAZDA

2006 on Mazda BT50 All Models 600224

MITSUBISHI

4/00 on Pajero NS, NM & NP (3.2 Diesel) *90007 / 900064/00 on Pajero NS, NM & NP Wagon & Hard Top (V6) *90007 / 9000691 to 3/00 Pajero (Coil Springs) NH, NJ, NK & NL 6004091 to 3/00 Pajero (Leaf Springs) NH, NJ, NK & NL 600402006 on Triton ML All Models 90008

2/00 on Patrol Y61 (GU) Series II SWB & Wagon *60013 / 60012 OMESD01

97 to 1/00 Patrol Y61 (GU) Series I Wagon & SWB *60013 / 60012 OMESD11

97 on Patrol Y61 (GU) Cab Chassis (Leaf Spring Rear) *60013 / 60012

97 on Patrol Y61 (GU) Cab Chassis (All Coil Springs) *60013 / 60012 OMESD11

To 8/89 Patrol Y60 (GQ) Wagon & SWB *60013 / 60012 OMESD34

9/89 on Patrol Y60 (GQ) Wagon, SWB & Cab Chassis *60013 / 60012 OMESD36

2005 on Pathfinder R51 90003

2005 on Navara D40 90003

1/86 to 8/02 Navara D21 & D22 Pick Up 600212 OMESD356

10/02 on Navara D22 60034 2

A RECOMMENDATION FOR CUSTOMERS BUYING 4 REPLACEMENT SHOCK ABSORBERS

If a softer valved Selection is fitted with a heavy rate spring the vehicle's rebound handling will be reduced. This will beevident by axle bounce over rough roads, dipping under braking or cornering and wallowing over undulating roads.

Soft Valving

Valved specifically for light to medium rate springs. Most suitable for customers wanting a comfortable ride and regularlycarry light to medium loads. Under full GVM load a slight amount of body roll during cornering and highway speedmanoeuvring can occur.

NITROCHARGER SPORT SELECTION

Where there is a choice of part numbers it is important the right selection is made with consideration given to type ofspring rates and customer applications.

Firm ValvingThe firm part number should be selected whenever heavy rate springs are fitted, as the valving has been specificallydeveloped to control the higher spring rates. The firmer valving will provide better control when cornering, while alsopreventing axle bounce over rough roads.

By the time a customer has decided to replace the old and well used original shock absorbers there is every chance thatthe original springs are also ready for replacement.

Therefore, the life expectancy of the shock absorbers will be considerably shortened and when loaded ride and handlingqualities will also be reduced.REMEMBER: A good set of shock absorbers will not overcome a bad set of springs.

It should be explained to the customer that if their springs are sagged and tired that this would cause the shockabsorbers to work a lot harder.

OME NITROCHARGER SPORT STEERING

STABILISERSSHOCKS & STRUTS

*60039 / 60038

VEHICLE DESCRIPTION REAR

60023

60032

60032

LAND ROVER

*60025 / 60026*60039 / 60038

NISSAN

*60039 / 60038

60023

*60033 / 60019*60033 / 60019

60041N/A

60036

*60015 / 600143

*60015 / 600143

N/A

*60015 / 600143

*60015 / 60014

*60015 / 60014

60016

60017

60035

60035

YEAR FRONT

TOYOTA

2007 on LandCruiser 200 Series V8 90005 5

3/98 on LandCruiser 100 Series (IFS) *60001 / 60000

3/98 on LandCruiser 100 & 105 Series (Front Live Axle) 60018 OMESD24

4/90 to 98 LandCruiser 80 Series 60018 OMESD244/2003 on Prado 120 Series (Except Grande Models) 900007/96 to 10/02 Prado 95 & KZJ90 Series 90004

2007 on LandCruiser 78 & 79 Series V8 Diesel Model 60008 OMESD47

2007 on LandCruiser 76 Series Wagon - V8 60008 OMESD47

99 to 2006 LandCruiser 78 & 79 Series - 6 cylinder models 60008 OMESD24

85 to 99 LandCruiser 75 Series 60009 OMESD24

2005 on 90002

1.

2.

3.

to sway bar due to increased wheel droop.

4.

5.

6.

7.

OME NITROCHARGER SPORT STEERING

STABILISERSSHOCKS & STRUTS

NITROCHARGER SPORT SELECTION

*60011 / 600101

VEHICLE DESCRIPTION REAR

*60030 / 60029

*60003 / 600021

600201

600201

*60005 / 60004*60027 / 60028

*60011 / 60010

*60011 / 60010

Shock lower body stone guards are recommended fitment to rear shocks to protect against severe stone peppering encountered

*60011 / 600101

HiLux KUN26R, GGN25R *60007 / 60006

9/97 to 04HiLux LN172, LN167, KZN 165, RZN174 &

60042 60043 + 60044 7 OMESD33RZN169 (IFS)

NOTES: *first part number has firmer valving.

60043 is 20mm longer and must only be installed to right hand side.

on loose road surfaces. OME661 (suit LandCruiser 80 & 100 Series only) OME660 (all other models).

It may be necessary to slightly increase the clearance in the front wishbone to allow the shock absorber to fit. Do not modify the shock absorber.

FK18 rear sway bar extension bracket for LWB models and FK24 for SWB models are mandatory fitment with Nitrochargers to prevent damage

FK22 support brackets must be installed to upper shock mounting brackets on late 1996 on models manufactured in Thailand.

OME Struts can only be installed with OME Coil Springs.

OMESD35 will suit D21 models only.