Support HandbookHow to cut the capacitors in ONE500.

How to cut the capacitors in ONE500Support Handbook

1 Introduction.

This is a guide to fix the incidence on the capacitors of the ONE power board.

The devices affected by this error has a serial number between 18324353 and 18475508

If you have nay questions about how to proceed at any time during the operation, no not hesitate to contact to LDA Support Department: support@lda-audiotech.com

LDA Audio Tech - Severo Ochoa Nº 31- 29590 MÁLAGA, ESPAÑA. Tlf: +34 952028805

How to cut the capacitors in ONE500Support Handbook

2 HOW TO CUT THE CAPACITORS.

Step by Step.

1. Make sure that ONE is disconnected from external current.

2. Remove the cover and check the power switches “main” and “battery”, the both mustbe in “OFF”.

3. Remove the power cables from the suply board, the order to conect it again isPOSITIVE, NEGATIVE (External suply) NEGATIVE, POSITIVE (BATTERY) from left to rigth.

LDA Audio Tech - Severo Ochoa Nº 31- 29590 MÁLAGA, ESPAÑA. Tlf: +34 952028805

How to cut the capacitors in ONE500Support Handbook

4. Wait 2 minutes for capacitors download.

5. Unscrew and remove the metal cover that protects the power suply board.

LDA Audio Tech - Severo Ochoa Nº 31- 29590 MÁLAGA, ESPAÑA. Tlf: +34 952028805

Ilustración 1: Titled pictureexample

How to cut the capacitors in ONE500Support Handbook

6. Carefully cut the ceramic part of the capacitors C-113 and C-114.

7. Please, clean the remains of the operation.

8. Please, replace the metal cover, connect the stwitches “main” and “battery” in “ON”mode, put on the surface cover and finally, conect ONE to the external current.

For more information, please, contact with our Support Department at:

support@lda-audiotech.com

LDA Audio Tech - Severo Ochoa Nº 31- 29590 MÁLAGA, ESPAÑA. Tlf: +34 952028805