SUPPO Model OSD Manual OSD input and output connection：

Buttons and signal light:

“Set home” record home location, Max RSSI, clear timer, clear distance value

“Menu” Call system configuration menu

“Option SW” Switch between configuration options

“Select” Select each Option’s value

“Reset” Restart OSD

Signal Light Off : No power; On: connecting GPS; Flash: working good

Input and Output connectors definition diagram:

Typical FPV with OSD set up: (Video transmitter and Camera Not included)

1. Connect ‘Video in” from your Camera

2. Connect “Video out” to your wireless A/V transmitter

3. Connect 5V power (from BEC Provided or other power source) to power up your OSD

4. Connect GPS and select the right voltage for your GPS by setting the “GPS Volt Jumper”

5. Connect your main power battery to monitor your main power battery voltage;

6. Connect RSSI to your RC Receiver (Warning: potential dangerous, could damage your RX.

not recommend to do so if you don’t understand your RX well)

OSD Modules

Inter-connection

Setting and Configuring your OSD:

Press “Menu button” to enter system configuration

Use “Option SW” and “Select” button to configure

Mode 1，with longitude and latitude.

Mode 2,

Time Shown

(GMT-8)

Setting RSSI Min – Max value:

1. On ground power up TX and RX, press “set home” button, OSD will record RSSI Max;

2. On ground, power off TX, press “Menu” button, OSD will record RSSI Min value.

3. Select Save and Exit to save RSSI Min Max value.

OSD Modules and accessory including:

1. OSD main modules;

2. GPS;

3. BEC;

4. Wires.

Notes:

1. GPS first start will take 1-3 minutes. Re-start only 10 second.

2. Please note that you need to configure your “HOME” location with each time to get the

right “Flight Distance” and “Home Distance”, and “Return Course”

3. Time shown is GMT – 8, Pacific Time USA.

Specifications:

OSD Volt 5V BEC input 7-12V in Weight

GPS Volt 3.3V BEC output 5V /1.5A OSD 17.5g

System

Consumption

0.165A

0.825W

GPS

BEC

15.5g

1.7g