8/9/2019 Sun Force

1/3

SOLAR

20 LED

SHED LIGHT

Users anual

8/9/2019 Sun Force

2/3

Introduction

Thank you for purchasing the Sunforce Products Solar Shed Light. Used

carefully and in accordance with the instructions set out below, Solar

Shed Light should give you many years of trouble free use. Please read the

instructions carefully prior to usage.

Features:

Small and compact design

Easy to install

Dual Settings Bright 20 LEDs - Dim: 10 LEDs (energy saving)

3X Ni-Cd AA 800 mAh 1.2 Volt rechargeable batteries Weather proof solar panel

Equipped with 20 ultra bright LEDs

Includes three rechargeable batteries

Manual ON/OFF override switch.

Location SOLAR Collector:

1) For the best result, please locate your solar panel in a position where

it receives direct sunlight and is generally free from cover and shade.

Be aware of foliage and building overhangs, when placing the Solar

Collector. For best results please, allow the Solar Collector, to

receive sun for 48 hours, as an initial set-up.

Assembly Instructions:

Wall mount

1.

Carefully remove the Solar Shed Light and all the fittings from theshipping box

2. The Solar Light can be mounted with screws. Measure the distance

between screw holes located on the back plate. Mark the area and

place screws to the appropriate location. Secure the Solar Light to

pre-drilled screws.

Operation

1. For daily / normal operation, pull the ON/OFF cord down once to

illuminate.

2.

Slide the switch the right to illuminate all 20 LEDs and left for

the power saving 10 LED position.

3. The red LED will illuminate when the solar collector is connected

and charring the internal batteries.

Replacing the Batteries

For best results, batteries should be replaced every 12 months.

8/9/2019 Sun Force

3/3

Battery charging performance will vary with the time of year, and access

to sun

1. Take off the battery compartment cover.

2. Remove old batteies noting orientation of terminals.

3. Install the new batteries in to the battery compartment, ensuring

correct polarity

4. Replace battery compartment cover.

Trouble Shooting

1) Ensure the Solar Collector is free from shade, during the day

2) Check that the batteries are installed correctly and charged.

Maintenance

Clean the solar collector regularly with a damp cloth to guarantee

optimum performance. Do not use any type of solvent for cleaning and be

careful or abrasive surface.

Warranty

This product is covered by a 1 year limited warranty. Sunforce Products

Inc warrants to the original purchaser that this product is free from

defects in materials and workmanship for the period of one year from date

of purchase.

To obtain warranty service please contact Sunforce Products for further

instruction, at

1-888-478-6435 or email info@sunforceproducts.com. Proof of purchase

including date, and an explanation of complaint is required for warranty

service.

For more information or technical support

1-888-478-6435www.sunforceproducts.cominfo@sunforceproducts.com

MADE IN CHINA