sublimation transfer paper printing for fabric lamps

A fabric lamp is like a sweater tied around the shoulders—cooly effortless but done with stylistic intent. Swapping a glass or metal fixture for fabric adds an instant ease and lightness to a room. The design world has certainly caught on. Some night would be so romantic.

Here some steps that teach you how to produce a fabric lamp.Step1: Download from computer with sublimation transfer paper and printing it into fabric

From computer, print it out and enlarge it. It is not likely to print on one piece of 11x17" paper unless you get it at just the right angle so it may be easier to enlarge half of the pattern at a time. Tape the two copies together after matching the lines. Depending on the type of fabric that you use, you may want to use fusible interfacing. I used a fairly thin vintage cotton that benefited from interfacing, but if you use a heavier fabric it won't be necessary. If you do think your fabric will benefit from it.Follow the directions on the package to fuse. The kind I used required I lay the fusible side down on the wrong side of the fabric, cover with a damp cloth and press with a hot iron. Very easy.

To begin sewing, lay two pieces with right sides together and pin along one edge. I put pins 3/4 of an inch from either end as markers for where to start and stop sewing. You will need the very top and bottom to remain open so that later you can turn it right side out and fit it over the lamp post. Once the first two pieces are sewn, continue matching piece by piece with like sides together, pinning and sewing until you have made it all the way around the lamp. There will be six seams. Fortunately, these fold up like an accordion as you move to each new section, so you'll find it easy to keep extra fabric out of your way while you are pinning and sewing.

Clip and StuffYou should now have what looks like a deflated balloon. The next step is to clip the seams so that when you turn the "balloon" right side out you will have nice, smooth seams.

Now it's time to assemble your lamp. After screwing 1 nut followed by 1 washer onto one end of the threaded lamp pipe, stick it into the top of the fence post cap. Tighten a second nut on the underside of the fence post cap.Then adhere the 4 vinyl feet to each corner of the base. This will make the lamp more stable and will also create clearance for the cord.

Once you have your fabric base anchored on the lamp pipe, make sure that the stuffing is even and full. When you are happy with it, sew the top closed using a running stitch in a circle near the top. By tightening your thread, you'll close the top.

With the washer in place at the top of the lamp, screw on the base of the light fixture socket. Push the cord up through the base and out through the socket cap at the top and tie what is called an underwriter's knot. There are two screws on either side of the socket. Loosen these screws slightly. Wrap the ribbed wire around the silver screw and the other wire around the brass screw. Tighten with a screwdriver.Pull the extra wire back into the lamp and snap the socket down into the cap and you are done!

More info pls visit: www.hitransfer.comCompany name:Nanjing Hi Transfer Digital Technology Co.,LimitedTel: 86-25-85862106Fax: 86-25-85862106Mail: sales@hitransfer.comWeb: www.hitransfer.com