STRAIGH-THRU 568B UTP CABLE - CNC4PC
1
12-24VDC POWER SUPPLY 36VDC POWER SUPPLY L N L N V- V- V V + + SW1=OFF SW2=ON SW3=OFF SW4=OFF DISABLE SOFT ENABLE NOT REQ ENCODER AXIS X GND CASE 1 2 3 E-STOP http://www.cnc4pc.com Designed : Revised : YAC Date : Date : Item : Ver. : Description : G320 AND C62 JPM AUGUST-02-2018 WS_48 1 AUGUST-02-2018 STRAIGH-THRU 568B UTP CABLE X C62 Rev.5 C34G320X Rev. 6 Note * This wiring diagram is valid for Revision 6 of the C34G320 and newer * The negative of the C32 should remain isolated from the negative of the main power supply. This can be verified by using a multimeter in beep mode and touching the terminals for both grounds. DISABLE
Transcript of STRAIGH-THRU 568B UTP CABLE - CNC4PC
12-24VDCPOWER SUPPLY
36VDCPOWER SUPPLY
L N L NV- V- V V+ +
SW1=OFFSW2=ON SW3=OFFSW4=OFF
DISABLE
SOFTENABLE
NOT REQ
ENCODER
AXIS XGND CASE
123
E-STOP
http://www.cnc4pc.com
Designed :
Revised : YAC
Date :
Date :
Item : Ver. :
Description :
G320 AND C62
JPM AUGUST-02-2018
WS_48 1
AUGUST-02-2018
STRAIGH-THRU 568B UTP CABLE
X
C62 Rev.5
C34G320X Rev. 6
Note* This wiring diagram is valid for Revision 6 of the C34G320 and newer* The negative of the C32 should remain isolated from the negative of the main power supply. This can be verified by using a multimeter in beep mode and touching the terminals for both grounds.
DISABLE