Step by Step IVNGWC 2011 01
-
Upload
rodrigo-gonzalez-maceda -
Category
Documents
-
view
64 -
download
3
Transcript of Step by Step IVNGWC 2011 01
![Page 1: Step by Step IVNGWC 2011 01](https://reader035.fdocuments.net/reader035/viewer/2022081717/547ede34b4795989508b4cbd/html5/thumbnails/1.jpg)
step-by-step January 2011
©by IVNGWC.org - commercial use including excerpts is not allowed - use for educational purposes only under mentioning of this source
![Page 2: Step by Step IVNGWC 2011 01](https://reader035.fdocuments.net/reader035/viewer/2022081717/547ede34b4795989508b4cbd/html5/thumbnails/2.jpg)
©by IVNGWC.org -commercial use including excerpts is not allowed -
use for educational purposes only under mentioning of this sourcepage 2 of 6step-by-step IVNGWC 2011-01
step step
Skizze für Drehung und für abtragende Drehung Drehung
1 2
![Page 3: Step by Step IVNGWC 2011 01](https://reader035.fdocuments.net/reader035/viewer/2022081717/547ede34b4795989508b4cbd/html5/thumbnails/3.jpg)
©by IVNGWC.org -commercial use including excerpts is not allowed -
use for educational purposes only under mentioning of this sourcepage 3 of 6step-by-step IVNGWC 2011-01
step step
Arbeitspunkt an Schnittlinie von Rundung und Rippenkante aus
Skizze 1 erstellen
Arbeitsebene durch Arbeitspunkt, parallel zur Grundfl äche
3 4
![Page 4: Step by Step IVNGWC 2011 01](https://reader035.fdocuments.net/reader035/viewer/2022081717/547ede34b4795989508b4cbd/html5/thumbnails/4.jpg)
©by IVNGWC.org -commercial use including excerpts is not allowed -
use for educational purposes only under mentioning of this sourcepage 4 of 6step-by-step IVNGWC 2011-01
step step
Skizze auf Arbeitsebene. Mittelpunkt der kurzen Seite des Recht-
eckes gleich setzen mit prejeziertem Arbeitspunkt
Extrusion „zwischen“ Grundfl äche und Oberkante
5 6
![Page 5: Step by Step IVNGWC 2011 01](https://reader035.fdocuments.net/reader035/viewer/2022081717/547ede34b4795989508b4cbd/html5/thumbnails/5.jpg)
©by IVNGWC.org -commercial use including excerpts is not allowed -
use for educational purposes only under mentioning of this sourcepage 5 of 6step-by-step IVNGWC 2011-01
step step
Abtragende Rotation mit Skizze 1 Rundung
7 8
![Page 6: Step by Step IVNGWC 2011 01](https://reader035.fdocuments.net/reader035/viewer/2022081717/547ede34b4795989508b4cbd/html5/thumbnails/6.jpg)
©by IVNGWC.org -commercial use including excerpts is not allowed -
use for educational purposes only under mentioning of this sourcepage 6 of 6step-by-step IVNGWC 2011-01
step step
Bohrung nach Skizze Runde Anordnung von Bohrung und Rippe.
Fertig
9 10