Stellar Parallax

31
Continuous Spectrum of Light 3.1 Stellar Parallax d(pc) = 1/p” where p” is the parallax in arc seconds d(pc) is the distance in parsecs 1 pc =3.26 light years and is the distance at which a star would have a parallax of 1”

description

Chapter 3 Continuous Spectrum of Light 3.1 Stellar Parallax d(pc) = 1/p” where p” is the parallax in arc seconds d(pc) is the distance in parsecs 1 pc =3.26 light years and is the distance at which a star would have a parallax of 1”. Stellar Parallax. - PowerPoint PPT Presentation

Transcript of Stellar Parallax

Page 1: Stellar Parallax

Chapter 3Continuous Spectrum of Light

3.1 Stellar Parallaxd(pc) = 1/p”

where p” is the parallax in arc seconds

d(pc) is the distance in parsecs 1 pc =3.26 light years and is the distance at which a star would have a parallax of 1”

Page 2: Stellar Parallax

Stellar Parallax

Page 3: Stellar Parallax

Chapter 3.2The Magnitude ScaleApparent Magnitude – Invented by Hipparchus. The brightest stars were 1st magnitude and the faintest, 6th magnitude. The lower the number, the brighter the star. Norman Pogson discovered that a difference of 5 magnitudes corresponds to a factor of 100 in brightness. A difference of 1 magnitude corresponds to a brightness ratio of 1001/5 ~ 2.512.

Page 4: Stellar Parallax

The Magnitude ScaleApparent Magnitude – A first magnitude star is 2.512 times brighter than a 2nd magnitude star, etc. Apparent magnitude, m, for the sun -26.83. Faintest object detectable, m = 30. Faintest star a person with 20/20 vision can see is ~6th magnitude.

Page 5: Stellar Parallax

The Magnitude ScaleAbsolute Magnitude – This is the apparent magnitude a star would have if it were 10 parsecs or 32.6 light years distant.

Page 6: Stellar Parallax

Radiant FluxA star’s brightness is the total amount of starlight energy/second at all wavelengths (bolometric) incident on one square meter of detector pointed at the star. This is called the radiant flux, F and is measured in watts/m2.

Page 7: Stellar Parallax

LuminosityLuminosity, L is the total amount of energy emitted by a star into space.

Page 8: Stellar Parallax

Inverse Square Law

The relationship between a star’s luminosity L, and its radiant flux, F is:

where r is the distance to the star.

Page 9: Stellar Parallax

Inverse Square Law

Knowing the values for the sun’s luminosity, L and using 1 AU for the average Earth-sun distance, for r, the solar flux, F received by the Earth from the sun is:F = 1365 W/m2, This is also known as the solar constant.

Page 10: Stellar Parallax

Distance ModulusA measure of the distance to a star is called its distance modulus, or m – M. m – M = 5log10(d) – 5 = 5 log10 (d/10 pc)

Remember, that M is the magnitude a star would have if it were 10 pc (parsecs) distant.

Page 11: Stellar Parallax

Distance ModulusThe distance modulus is a logarithmic measure of the distance to a star. Here’s a listing of m, M, and m – M of notable stars:Star Name m M m – M

Sirius -1.5 1.4 -2.9 Alpha Centauri A 0.0 4.4 -4.4 Alpha Centauri B 1.4 5.8 -4.4 Proxima Centauri 10.7 15.1 -4.4 Sun -26.75 4.83 -31.58

Page 12: Stellar Parallax

Distance ModulusExample to calculate the M of Proxima Centauri:m – M = 5 log10 (d/10 pc)

M = m - 5 log10 (d/10 pc)

For Proxima Centauri, d = 1.295 pc, m = 10.7 (it’s a red dwarf).M = 10.7 - 5log10 (1.295/10) = 15.1

Page 13: Stellar Parallax

Chapter 3.4Blackbody Radiation

A blackbody is defined as an object that does not reflect or scatter radiation shining upon it, but absorbs and reemits the radiation completely. It is a kind of ideal radiator, which cannot really exist. However, stars and planets behave as if they were blackbodies.Blackbody radiation depends only on its temperature and is independent of its shape, material and construction.

Page 14: Stellar Parallax

Latest Spectrum of SN2014J

Page 15: Stellar Parallax

Blackbody RadiationThis figure shows the blackbody spectrum of an object has a certain peak, and goes to shorter wavelengths as the temperature increases.

Page 16: Stellar Parallax

The Planck Function

where h = Planck’s constant = 6.626 x 10-34J sand the units of Bl(T) are W m-3 sr-1

Page 17: Stellar Parallax

Wien’s LawNotice that the peak of a BB curve goes to shorter and shorter wavelengths as T increases. This is Wien’s Law.

lmaxT = 0.0029 m K

Page 18: Stellar Parallax

Chapter 3.4Blackbody Radiation

Remember this animation site?

http://www.astro.ubc.ca/~scharein/a311/Sim.htmlIt has a great blackbody simulation/animation!

Page 19: Stellar Parallax

Wien’s LawExample: 3.4.1What is lmax for Betelgeuse? Its temperature is 3600 K.

which is in the IR.

Page 20: Stellar Parallax

Wien’s LawExample: 3.4.1Similarly for Rigel. What is lmax for Rigel? Its temperature is 13,000 K.

which is in the UV.

Page 21: Stellar Parallax

Chapter 3.6Color Index

The Johnson - Morgan UBV Filter System

Page 22: Stellar Parallax

Chapter 3.6Color Index

The Johnson - Morgan UBV Filter SystemApproximate central wavelengths and bandwidths are:Band < λ > ( A) ∆λ ( A) U 3600 560 B 4400 990 V 5500 880

Page 23: Stellar Parallax

Color IndexColor index is related to a star’s temperature. Figure below is from http://csep10.phys.utk.edu/astr162/lect/stars/cindex.html

Page 24: Stellar Parallax

Returning to The Planck Function

where h = Planck’s constant = 6.626 x 10-34J sand the units of Bl(T) are W m-3 sr-1

Page 25: Stellar Parallax

Exploring the Planck FunctionLet’s investigate this function.

The exponent in the denominator is sometimes written as b. And b = hc/lkT, has no units, ie. it is dimensionless.h = 6.626068 x 10-34 joule sec k =1.38066 x 10-23 joule deg-1 c =2.997925 x 108 m/s T = object temperature in Kelvins

Page 26: Stellar Parallax

Example Using the Planck Function

Let’s do an example with this function. Consider an object at 213 K and let’s compute the emitted radiance at 10 microns. Everything is in SI units, i.e. meters and joules. We have that b =,

Notice that all of the units cancel.The denominator of the Planck function is e6.77-1 = 870.3

Page 27: Stellar Parallax

Example Using the Planck Function

The numerator becomes2(6.63×10−34 Js)(3.0×108 m/s)2 (1.0×10−5 m)−5 =119.3×107 Jm−3s−1steradian−1

The full Planck function becomesB =119.3×107 /870.3 = 0.137×107 Jm−3s−1steradian−1

and the units of Bl(T) are W m-3 sr-1

Page 28: Stellar Parallax

Back to Color Indices and the Bolometric Correction

A star’s U – B color index is the difference between its UV and blue magnitudes.A star’s B – V color index is the difference between its blue and visual magnitudes.The difference between a star’s bolometric magnitude and its visual magnitude is its bolometric correction BC.A bolometric magnitude includes extra flux emitted at other wavelengths. The magnitude adjustment that takes into account this extra flux is the bolometric correction.

mbol – V = Mbol – MV = BC

Page 29: Stellar Parallax

Color Indices and the Bolometric Correction

One can associate an absolute magnitude with each of the filters.U – B = MU – MB

B – V = MB – MV

The difference between a star’s bolometric magnitude and its visual magnitude is: mbol – V = Mbol – MV = BC

Page 30: Stellar Parallax

Bolometric CorrectionThe significance of the bolometric correction is that, the greater its value, either positive or negative, the more radiation the star is emitting at wavelengths other than those in the visible part of the spectrum.This is the case with very hot stars, where most of their radiation is in the UV. The BC would be negative.This is also the case with very cool stars, where most of their radiation is in the IR. The BC would be posative.The BC is least with sun-like stars, since most of their radiation is in the visible part of the spectrum. The BC would ~ 0.

Page 31: Stellar Parallax

Example Using Bolometric Correction

For Sirius, U = -1.47, B = -1.43, V = -1.44

U – B = -1.47 –(-1.43) = -0.04

B – V = -1.43 – (-1.44) = 0.01

This shows that Sirius is brightest at UV wavelengths, which is what you would expect, since T = 9970 K.

which is in the UV part of the electromagnetic spectrum. The bolometric correction for Sirius is BC = -0.09. Apparent bolometric magnitude is:

mbol = V + BC = -1.44 + (-0.09) = -1.53

BC is negative for a hot star like Sirius. BC is positive for a cool star like Betelgeuse.