Static charges in vertical form fill and seal machines
-
Upload
ate-private-limited -
Category
Business
-
view
20 -
download
1
Transcript of Static charges in vertical form fill and seal machines
VALENCE ELECTRONS PRIVATE LIMITED 32 K R Colony, Domlur Layout, Bangalore 560 071, India T: +91-80-4125 6570 E: [email protected] W: www.ategroup.com/valence Registered Office: 43 Dr V B Gandhi Marg, Fort, Mumbai 400 023, India CIN: U74999MH2000PTC127595
Application note
Published date: 10-01-2017 | Rev: 1A
Page 1
Static charges in vertical form fill and seal machines
Problem
On a vertical form fill and seal machine, electrostatic charges are produced when the packaging film is fed
from the winding roll. Static charges attract dust onto the inner and outer surfaces of the pouch / bag. This
hampers effective sealing and also could lower the appearance of packaging.
Solution
In order to eliminate the static charges, it is recommended to use Valstat® VR 20 AC static eliminating bars
after the unwinder and on the filling area as shown in the above diagram.
Depending on the need, Valstat®
circular profile static eliminators may be used in the sealing area.