So what is stop/start technology ??

Why manufacturers are so keen on installing it to every car??

The system is designed to make the optimum use of fuel in idling situation also…

The ultimate goal is a better fuel efficiency and low running cost…

All the Manufacturers are aware of this situation…

They have installed all new stronger motors, more resilient batteries, and new cylinder liners to get activate immediately before a repeat starts….

How The Technology Works ????

Vehicle is in halt position due to traffic jam ….

Neutral gear is on in the vehicle …

But before the stop, the indicator of start/stop will blink and informs you about the engine is going to shut down shortly…

After the engine stops, the indicator will constantly glow and inform you about the engine has stopped

Now the signal turns green, you just need to press the clutch pedal ..

The indicator will go off and engine starts immediately….

Now your vehicle is ready for drive….….

Does the technology has any drawbacks ????

Most of these systems required high electric load to perform properly that’s not available in some vehicles

Some systems do not allow the engine to stop for too long….

But except all these, the start-stop technology has a turn-off switch to disengage the function from vehicle…

Website: http://www.europeanservicecenter.com/dallas-uptown/

https://twitter.com/EuropeanDallas