SSTB-EXPL SecureStor SUV VaultFord Explorer Mounting Instructions

CAUTION: Always check before drilling or screwing to be certain not to hit anything (fuel tank,lines, wiring, etc) beneath the carpet, the transmission hump or the vehicle.

Front Mounting: Lift both floor covers and install (2) front “L” brackets to vehicle mountingbolts using factory bolt. (Figure 1) No drilling required.

Rear Mounting: Measure 22” back (from center of front bracket to center of rear bracket). Attach mounting bracket to vehicle floor using supplied 5/16” sheet metal screws. (Figure 2)Re-install covers and mount vault using 3/8 “ hardware supplied and side brackets.

Helpful installation tip: The vault mounting bolts can be threaded halfway into the sides ofthe vault before installation. Then the vault can be lifted to drop down over the slotted bracketsdue to the space limitations in the rear cargo area..

Important option: To be able to remove the spare tire without removing the vault, a 2”holemust be drilled in the back plastic floor panel to align w/ the tire-drop hole under the cover.Be certain to remove jack for later use before installing vault.

SPECIALISTS IN EMERGENCY VEHICLE PRODUCTS SINCE 1978 • DESIGN, MANUFACTURING, DISTRIBUTION AND INSTALLATION

01/10

Figure 1 Figure 2

22”