Spirithood Sewing Pattern by Djdeathstar-d5f5gx5

8/21/2019 Spirithood Sewing Pattern by Djdeathstar-d5f5gx5

1/13

Hello! Thank you for downloading Alexs SpiritHood/custom animal hood sewing pattern!

This PDF contains the 9 pages that make up the sheet from which you will cut out all of the necessary

pattern pieces. I have also included a photo of the pattern sheet printed out and assembled, so you can

see how the pages go together (they are numbered 1-9 and go together 3x3). Even though this is

considered a simple sewing project, it is still a sewing project none-the-less and requires that you knowhow to read and use patterns.

ALSO! I didnt redraw the pattern to include this, but before you cut the liner pieces for the scarf and

hood, ADD AN EXTRA 1-2 CM TO THE PATTERN IN ADDITION TO THE ALREADY DRAWN SEAM

ALLOWANCE BECAUSE OTHERWISE THE LINER WILL END UP BEING A BIT TOO SMALL AND WILL TWIST

OR PUCKER WHEN THE HOOD IS FINALLY TURNED RIGHT SIDE OUT.

If you want the scarf part to have stripes, use tissue to trace the scarf pattern piece and then add 2cm of

extra length for each colored section you want to have (this is the extra seam allowance that will cover

the amount of material that gets used when you sew a bunch of sections together- 1cm for the top and

bottom of each section). Draw new lines do divide the scarf into the number of sections you added seam

allowance for and cut along these lines. NOTE that this trace-and-cut only needs to be done for the shell

(fur) part of the scarf. Cut the liner part of the scarf as indicated.

Materials required:

1 yard of faux fur

1 yard of liner fabric (I used a cotton jersey for mine but you could also use satin or fleece or

anything else depending on the look youre going for.)

1 foot of contrasting fabric for the paw pads

Thread

(Optional) scrap fabric and a grommet to make an earring tag

Suggested order of assembly (this is how I did it):

1.

Print the pattern and measure the test sheet square to make sure it measures 4x4.

2.

Tape the sheets together and cut out the pattern pieces.

3.

Trace and cut out the fabric pieces. (Cut the faux fur from the back (wrong) side- you end up

with fewer fuzzies everywhere that way.) Make sure you place the pattern pieces on the fur

according to the pile direction arrows indicated.

4.

Sew the shell pieces together (minus the pockets).

5.

Sew the liner pieces together. This is also where you would sew the paw pads onto the ends of

the scarf liner pieces.

6.

Sew each of the ears (liners to shells), adding a tag with a grommet if you so desire (I added

one to mine in a similar fashion to what SpiritHoods does with their ears- its so you can clip

earrings to it).

7.

Set the assembled shell on a willing volunteers head when pinning the ears. This way you can

get the placement just the way you want and youll know for sure that the ears will sit correctly.


2/13

8.

Hand-stich the ears to the shell.

9.

Sew the pocket liners to the pocket shells (but only the top opening of the pocket! The

remaining sides will be closed when the pocket is sewn in with the liner and shell).

10.

Final assembly: pin the assembled liner to the assembled shell inside-out, sandwiching the

assembled pocket pieces between the right sides of the shell and liner. Because of the added

bulk, the bottoms of the scarf ends will be difficult to get through the sewing machine but be

patient and go slow! (Theres nothing more frustrating than completing a difficult seam only to

discover that a section of material escaped.) Sew the liner and shell together starting a few

inches from one side of the center of the hood base, ending a few inches from the other side.

This leaves a hole just large enough to pull the hood right side-out. Before doing so however,

zig-zag stich the raw edges where the liner and shell were sewn together to compress and

strengthen the seams.

11.

Turn the hood right side out!

12.

Verify that everything sits properly and that no seams have to be pulled and redone.

13.

Hand stich shut the hole you pulled the hood through.

14.

Youre done! Enjoy your brand-new custom SpiritHood!

I have made this pattern free to download and share, but if you would like to make a small

donation to me as a thank-you, my PayPal is [email protected](go to PayPal.com

and select Money Transfer and follow the instructions!) Again, thank you for downloading

and have fun!


3/13


4/13


5/13


6/13


7/13


8/13


9/13


10/13


11/13


12/13


13/13

Spirithood Sewing Pattern by Djdeathstar-d5f5gx5

Documents

Transcript of Spirithood Sewing Pattern by Djdeathstar-d5f5gx5