SOC Tunneling
-
Upload
rasanavaneethan -
Category
Documents
-
view
47 -
download
6
description
Transcript of SOC Tunneling
-
(SOC TUNNELING)
SAFETY ORIENTATION COURSE
( 4 hrs course include exam )
-
SOC Tunneling Course : 4 hours
-
Course contentDuration: 4 hrs (Half day)
Our Training Objectives of this course. Accident Case Studies General Safety in Tunnelling Works Working Hazards in Tunnelling and NATM
Tunnelling Equipments and other Machinery Tunnelling Equipments and other Machinery
Tea Break
Confined Spaces safety Hot Work, (PTW) Working in the Compressed Air environment/ Medical Procedures for Safe Work Other Safety Precautions , Examination ( 3 set of MCQ)
-
Objective of this course
The main health hazards in tunnelling are exposure to dust,
toxic gases, noise, vibration, heat and humidity, manual
handling, and other hazardous materials .
After this course, tunnel workers should be able to recognize After this course, tunnel workers should be able to recognize
Risk & hazards when working with TBM or compressed air
environment, know the preventive measures to be adopted,
confident when working at shaft bottom or cut & cover
project and understand the importance of observing safety
signs and follow safe work procedures.
-
Lesson 1
Objective
Introduce
TrainingPersonal Protective Equipment part: 1
TrainingPersonal Protective Equipment part: 1
Site Rule & Regulations
Tall Board for safe entry
-
introduce
We must be proud with our job because not many of us have the experience to work in the underground or tunnel
Our job is highly appreciate because its bring strong economic to the country and to my family back home.
-
TRAININGAdequate Safety & health training is required
New tunnel workers must completed CSOC course
-
SITE SAFETY RULES & REGULATIONS
pay close attention on:
WEAR PROPER PPE AT ALL TIMES
HOUSEKEEPING
ELECTRICAL SAFETY
HOT WORK SAFETY HOT WORK SAFETY
DANGER OF LIFTING WORKS
FIRE PREVENTION
HEALTH MATTER
RISK & HAZARD
-
Regular Tool Box Meeting
Tunnel workers must attend & listen to daily tool box meeting that conduct by your foreman or WSH supervisor .
Workers are advised to raise questions, if you have any doubt in the jobin the job
You are also been advised to share good ideas on safe work practice during this short & meaningful tool box meeting.
-
Personal Protection Equipment
for tunnel workersfor tunnel workers
-
Personal Protection Equipment
for tunnel workers
Safety Helmets
Reflective vests
Safety boots/ rubber Safety boots/ rubber
Safety belts or harness
Eye protection
Ear protection
Hand goggles
Proper working clothes.
face Masks
-
Personal Protection Equipmentfor tunnel workers
-
Personal Protection Equipmentfor tunnel workers
Reflective vests
-
Tally Board System
Access and egress Access and egress
to tunnel & shaft
-
Tally Board System
Access and egress to tunnel & shaft
-
Tally Board
All personnel including visitor must register at the board before going down to the shaft or tunnel.
They must register OUT after leaving the tunnel or even to the toilet for the tunnel or even to the toilet for 5mins
The system is very simple :
Tag (white) mean OUT
Tag (red) mean INSIDE
-
Tally board system
The tally board system is a very important vital information to site management, fire & rescue or Civil defense and WSH dept.
The system must be accurate at all times.
In-case of a natural disaster or fire, the tally board will be able to advise us the correct number of advise us the correct number of person in the tunnel.
Safety personnel will imposed a
fine to those personnel who fail to
compliance the system
Strictly do not register for others.