SL Qstat 100

THE WAY TO MAKE IT | PRECISE

User-friendly & reliable

Technical data:

• Large graphical LCD display• Measuring range: 0 - 1000 N• Measuring units: N, Kgf, Lbf• Speed: 25, 50, 100 mm/min.• Accuracy: < 1% of full range• Resolution: 0,1 N

Transfer of crimp

specifications to

Qstat 100

Transfer of crimp

results to Qpex RS-232

Features:

• Multi-language support• Visualisation of pull force profile• Job queue status button for browsing of outstanding quality verification job sent by Qpex-CFM

Connectivity:

• Through serial communication interface the Qstat 100 allows external micrometer to be connected for crimp height/crimp width measurements. A one stop quality station for wire harnessing shop floor • Fully integrated with Qpex crimp force monitoring system to retrieve quality validation data of crimp connection specification via LAN/WiFi, to prevent production of wrong specification crimp connection

Software:

• SL Qstat PC-Software – matched to your device

• Connectivity: Mitutoyo micrometer• Network: RS 232 serial communication Ethernet LAN/WiFi• Power supply: 85-265 VAC; 50 Watt• Dimensions (LxWxH): 180 x 90 x 360 mm• Weight: ca. 10 kg

Hand actuated pulltester can give inconsistent data depending on the operator pull rate. The IEC stan-dard specifies that a pulltester should measure with a consistent pull rate.Qstat 100 is a motorized bench top pulltester equipped with a PWM speed controller, ensuring consistent pull speed throughout the entire measuring range; a wide spectrum of crimp connections as well as ultra-sonic welded connections can be tested using the 12 position standard terminal holder.

SLE quality engineering GmbH & Co. KGJosef-Buchinger-Straße 994481 GrafenauGermanyPhone +49 8552 9640 0www.sleqe.com