Sirona Cerec Inlab 4.1. The system uses CAM/CAM technology, which means that the whole production...
-
Upload
aiden-spakes -
Category
Documents
-
view
215 -
download
0
Transcript of Sirona Cerec Inlab 4.1. The system uses CAM/CAM technology, which means that the whole production...
The system uses CAM/CAM technology, which means that the whole production of prosthetic work is controlled by computer
Starting optical impression (scanning directly in the mouth with cerec AC unit with bluecam) instead of classical impression, designing anatomically shaped tooth, milling and finishing work.
USED FOR:
Production of ceramics crowns Production of bridges Production of veneers Production of zirconium frameworks
WHY?
perfect fit (24 microns sensitivity) biocompatible material minimize the number of patient visits
- productions crowns and brigdes and laminates in one visit
top quality material absolute accuracy - long lifetime of
work
OCCLUSAL MILLING OFFSET Apply or remove
material in the occlusal
direction over the entire occlusal surface.
MINIMAL THICKNESS RADIAL Set the minimum wall thickness in the horizontal direction. The software tries not to fall below this thickness when calculating the restoration suggestions.
MARGIN THICKNESSReinforce restoration margins with
additional material.– Simplifies handling of the restoration– Prevents splitting of the material
The additional material can be milled off manually before inserting the restoration.
Can be switched on and off
TYPES OF MATERIAL
Esthetic ceramics-luminosilicate glass
Structural ceramicsA)low glass contentB)no glass content-polycrystalline-alumina, zirconia