CODEAbbott Diabetes Care Inc. 1360 South Loop Road, Alameda, CA 94502 ART

3650

5 Rev

. 1 01

/16

FreeStyle LibreSensor Applicator

Aplicador del sensor

XXXXXXXXXXX

YYYY-MM-DD

XXX

CODE

Abbott Diabetes Care Inc. 1360 South Loop Road, Alameda, CA 94502 A

RT36504 R

ev. 1

08/1

5

Sensor Pack | Envase del sensorCustomer Service | Atención al cliente:

1-855-632-8658

XXXXXXXXXXX

XXX

YYYY-MM-DD

FreeStyle Libre

STEP 3

STEP 6

STEP 9

Get

Rea

dy

Ap

ply

Sen

sor

Pre

par

e Se

nso

r A

pp

lica

tor

Clean site with alcohol wipe. Allow site to dry before proceeding.

Peel lid completely off Sensor Pack. Unscrew cap from Sensor Applicator.

CAUTION: Sensor codes must match on Sensor Pack and Sensor Applicator or glucose readings will be incorrect.

Select site on back of upper arm.Do not use other sites as these are not approved and may result in inaccurate glucose readings.Note: Avoid scars, moles, stretch marks, lumps, and insulin injection sites. To prevent skin irritation, rotate sites between applications.

Refer to your User’s Manual for full system instructions and information.

Touchscreen

Home ButtonUSB Port

Sensor Pack

Reader

Place Sensor Applicator over site and push down firmly to apply Sensor.

CAUTION: Do not push down on Sensor Applicator until placed over prepared site to prevent unintended results or injury.

Make sure Sensor is secure. Discard used Sensor Applicator and Sensor Pack according to local regulations.

Gently pull Sensor Applicator away from your body.

Quick Start Guide

STEP 1

STEP 4

STEP 7

STEP 2

STEP 5

STEP 8

Line up dark mark on Sensor Applicator with dark mark on Sensor Pack. On a hard surface, press down firmly on Sensor Applicator until it comes to a stop.

Sensor Applicator is ready to apply Sensor.

CAUTION: Sensor Applicator now contains a needle. Do not touch inside Sensor Applicator or put it back into Sensor Pack.

Lift Sensor Applicator out of Sensor Pack.

Lid Cap

Sensor

SensorApplicator

Codes on labels must match

● 1 Assemble and Apply Sensor to the back of your upper arm

● 2 Start new Sensor with Reader

Wait 12 hours for start-up

You can check your glucose whenever you want for up to 10 days

Setup Overview

● 1 Assemble and Apply Sensor to the back of your upper arm

FLASH GLUCOSE MONITORING SYSTEM4.5”

4.5”

4.5”

No Active Sensor

10:23pm

Start NewSensor

ReviewHistory

350

250

150

50

236 mgdL

6am 10am 2pm

Glucose Going High

Check Glucose

Scan Sensor to checkglucose.

10:23pm

CheckGlucose

ReviewHistory

Ends in 10 days

Daily Patterns

Time In Target

Low Glucose Events

Sensor Usage

Logbook

Daily Graph

Average Glucose

Review History

1 / 2

hours

OKNew SensorStarting Up

12 Sensor can be used in:

350

250

150

50

350

250

150

50

92 mgdL

mg/dL

Food Note

TargetGlucose

Range

Rapid-ActingInsulin Note

CurrentGlucose

Time

MessageTouch for more information

Check Blood GlucoseWhen you see this

symbol, do a blood glucose test before making treatment

decisions

Add NotesTouch to add notes to glucose reading

Current GlucoseGlucose from your latest scan

Glucose Trend ArrowDirection your glucose is goingGlucose Graph

Graph of your current and stored glucose readingsArrow What it means

Glucose rising quickly

Glucose rising

Glucose changing slowly

Glucose falling

Glucose falling quickly

Glucose Going Low

2pm 6pm 10pm

2pm 6pm 10pm

Press Home Button to turn on Reader.Note: If using Reader for the first time, follow the prompts to set date, time, and target glucose range.

Touch Start New Sensor. Hold Reader within 1.5 inches (4 cm) of Sensor to scan it. Sensor can be used to check your glucose after 12 hours.

Press Home Button to turn on Reader. Press Home Button again to go to Home Screen.

Touch Review History. Select option to view.

Hold Reader within 1.5 inches (4 cm) of Sensor to scan it.

Press Home Button to turn on Reader. Reader shows your glucose readings.

Understanding your glucose readings

If you have followed the instructions described in the User’s Manual and are still having difficulty setting up your System or if you are experiencing symptoms that are not consistent with your glucose monitoring, contact your health care professional.

STEP 3

STEP 3

STEP 3

STEP 1

STEP 1

STEP 1

STEP 2

STEP 2

STEP 2

FreeStyle, Libre and related brand marks are trademarks of Abbott Diabetes Care Inc. in various jurisdictions. ©2017 Abbott ART28734-018 Rev. B 09/17

Manufacturer

Consult instructions for use

WARNING: When you see the symbol, you must check your blood glucose with a blood glucose meter before making any treatment decisions. Sensor readings may not accurately reflect blood glucose levels.

● 2 Start new Sensor with Reader

● 3 Check your glucose

● 4 Review your history

4.5”

4.5”

4.5”