Setting up your iQ3 - Foxtel...*Free-to-air channels will vary based on location. Not all channels...
Transcript of Setting up your iQ3 - Foxtel...*Free-to-air channels will vary based on location. Not all channels...
2x
2x
2x
Setting up your iQ3
Need a helping hand? For troubleshooting or support visit foxtel.com.au/support or contact us via SMS on 0408 326 429
5 Tune your free-to-air channelsTo receive your free-to-air channels* from your TV aerial, check you’ve connected your iQ3 to your aerial wall plate, then:
Select Home, arrow left and select the Settings icon
Select Full Scan.Select Terrestrial Channels.
Select Begin Scan. Once the scan is complete select View TV Guide.
CUS
0272
_ 02_
1A F
X038
26 0
9/19
*Free-to-air channels will vary based on location. Not all channels are available in all areas.^Requires internet connected iQ3. Shows only available if they’re in your pack, some shows/channels not available.
3 Call 1300 732 681 to activate your iQ3
4 Connect your iQ3 to the internet
Select Home, arrow left and select the Settings icon
Select WiFi.Select Internet Connection.
Select your network. Enter your WiFi password, select Done and you will be advised once connected.
Access all the iQ3 features and stream^ On Demand content by connecting to WiFi following these simple steps:
1 First up, let’s check you’ve got all the goods
Remote and Batteries
iQ3 Box TV Aerial Cable and Adapter
Foxtel Cables x2 (new customers only)
HDMI Cable Power Pack
Input 1 Input 2
Digital Audio Out
Optical HDMI
12V DC5A max
USB5V DC 500mA
Coaxial
13V/18VDC350A maxCombined
TV aerial
2 Connect your iQ3 to your TV
Make sure your TV (and existing Foxtel box, if you have one) is turned off at the wall.
– If you’re upgrading your box, make sure to use the new Power Pack provided in this kit D .
– Once you’re connected, turn your TV back on and select the HDMI source you’ve connected to.
– You will see a black screen for a couple of minutes, then just follow the prompts.
– Once your new iQ3 is setup and turned on, insert the batteries into your remote whilst pointing it at the iQ3 – this will automatically pair. For more information, visit foxtel.com.au/remotepairing
To TV aerial wall plate (optional)
To Foxtel wall plate
To TV
To power point