Securus - Lite
2
System details Securus-Lite ™ Flat panel system 3.0 | High level security systems Experience the Difference... All information contained within this document including technical details, graphics and photographs are copyright © CLD Fencing Systems 2013. This document may not be reproduced, copied, transmitted or stored in any form without written permission from CLD Fencing Systems. All information correct at time of printing. We reserve the right to alter specification without notice. T +44 (0)1270 764751 F +44 (0)1270 757503 E-mail sales@cld-fencing.com www.cld-fencing.com Find out more Scan this QR code with your smart device to instantly access our website and find out what CLD can do for you. Head office: Unit 11, Springvale Business Centre, Millbuck Way, Sandbach, Cheshire, CW11 3HY Plan of panels in line Plan of end Plan of internal corner Plan of internal corner Securus Lite posts The CLD Securus Lite post is formed from square hollow section and from good grade steel. All bolts, clamps, washers and permacone fixings are galvanized for longevity. Finish All posts are galvanised and polyester powder coated either to match or contrast with the panels. Dimensions Posts: 60 x 60 mm SHS posts Corner posts: 60 x 60 mm standard SHS Post centres: 2440 mm Sloping ground Panels can be stepped as required on the post. Where gradients exceed 1:16, it is recommended that taller panels are either part-buried or additional posts are used. Panels can also be sloped to the following gradients, within the tolerance of the post section: 1.8 m high: 1 in 45 2.0 m high: 1 in 50 2.4 m high: 1 in 60 3.0 m high: 1 in 75 Variations The posts are available in different lengths to accommodate panel heights and ground conditions. • wall fixing plates, cranked posts or base plated • cranked or straight extensions for barbed or razor wire • cranked panels
Transcript of Securus - Lite
System details
Securus - Lite™
Flat panel system
3.0 | High level security systems
Experience the Difference...All information contained within this document including technical details, graphics and photographs are copyright © CLD Fencing Systems 2013. This document may not be reproduced, copied, transmitted or stored in any form without written permission from CLD Fencing Systems.
All information correct at time of printing. We reserve the right to alter specification without notice.
T +44 (0)1270 764751 F +44 (0)1270 757503 E-mail [email protected]
www.cld-fencing.com
Find out moreScan this QR code with your smart device to instantly access our website and find out what CLD can do for you.
Head office: Unit 11, Springvale Business Centre, Millbuck Way, Sandbach, Cheshire, CW11 3HY
Plan of panels in linePlan of end
Plan of internal cornerPlan of internal corner
Securus Lite postsThe CLD Securus Lite post is formed from square hollow section and from good grade steel. All bolts, clamps, washers and permacone fixings are galvanized for longevity.
FinishAll posts are galvanised and polyester powder coated either to match or contrast with the panels.
DimensionsPosts: 60 x 60 mm SHS posts Corner posts: 60 x 60 mm standard SHSPost centres: 2440 mm
Sloping groundPanels can be stepped as required on the post. Wheregradients exceed 1:16, it is recommended that taller panels are eitherpart-buried or additional posts are used. Panels can also be sloped tothe following gradients, within the tolerance of the post section:1.8 m high: 1 in 45 2.0 m high: 1 in 502.4 m high: 1 in 60 3.0 m high: 1 in 75
VariationsThe posts are available in different lengths to accommodate panel heights and ground conditions.• wall fixing plates, cranked posts or base plated• cranked or straight extensions for barbed or razor wire• cranked panels
3.0 | High level security systems
Visit www.cld-fencing.com/login.phpDrawn by Architects for Architects
ULTIMATE from 1.8 to 2.4m high panelsFoundation dimensions shown are illustrative only, contractor must prepare foundations in accordance with ground conditions.
All dimensions shown are subject to manufacturing tolerances.
END PLAN
IN-LINE PLAN
INTERNAL CORNER PLAN
EXTERNAL CORNER PLAN
FULL PANEL PLAN
2485 POST CENTRES
2430
2030
1780
2500 28
00
3200FenceCAD
CAD Drawings for Security Fences & Gate Systems
Securus- Lite™
Specification clausesTo be read with Preliminaries/General conditions.
Open mesh steel panel general purpose fencing/gates.
• Manufacturer & Ref: CLD Fencing Systems www.cld-fencing.com, Tel. 01270 764751, CLD Securus – Lite Flat Panel System.
• Height: ……* Nominal height: ……* Mesh & wire: 76.2 x 12.5 mm mesh; 4 mm wire, high aluminum content galvanised and polyester powder-coated to a minimum of 60 microns.
• Posts: 60 x 60mm SHS, Galvanized and polyester powder coated.
• Fixings: M8 cup square bolt with permacone nut and security washer.
• Maximum post centres: 2.44 m.
• Set posts: Set posts in holes 300 mm diameter x 750** mm deep, filled not less than half the depth with concrete.
• Bottom of fencing to be: maximum 50 mm above final ground level.
• Other requirements: PPC Colours Green RAL 6005 or galvanised only***.
FinishGalvanised and polyester powder-coated after stringent cleaning and treatment to give a well-adhered coating of a minimum of 60 microns. Also available as Galfan only which is a high aluminum content galvanising giving four times the life of BS 443. This finish is free of the sharps and irregularities found in the hot dip galvanising process.The full RAL range of colours available.
DescriptionThe Securus Lite flat panel system is a more cost effective anti-climb system, the mesh panels overlap the main posts with a slim clamp bar and easy fixings. This maintains security against the would be intruder. The Securus Lite system also conforms to Secured by Design and LPS1175 cat 1 at 2.4 and 3.0m high.
* See specification, above, for available heights
** Depending on fence height
*** Delete as required
Panel dimensions
Heights 1800, 2000, 2100, 2400, 3000 up to 5200 mm
Panel width 2514 mm
Mesh size 76.2 x 12.5 mm
Wire diameter 4 mm (horizontals and verticals)
Top edge projection Nil – wire is flush on all edges
Flat panel system
Exploded view of post and fixing details for Securus-Lite panel system
Find out moreScan this QR code with
your smart device to instantly access even
more information.
A
B
D
C
• Anti-climb mesh
• 60 x 60mm post
• Conforms to LPS1175 Cat 1
• Full range of RAL colours available
• Schools
• Industrial & Commercial units
• MOD
• Police Stations
• Secure Units
• Airports & Seaports
Suitable for:Features:
Excellent value for budget and security
“”
Galvanised and polyester powder coated RHS post
Anti-climb close mesh
Through bolt with security washer and non removable shear nut
Overlapping joints - reducing post centers
B
A
C
D
Secured by Design
Official Police Security Initiative
SBD
Police Preferred Specification
Cert No.999A
Secured by Design
Official Police Security Initiative
SBD
Police Preferred Specification
