Get Transmission Para of BS from

RNC/BSC

Transmission Mode; Radio Mode; E1/FE; HDLC; PPP; Global Port; IP;

OMCB Para;

Boards used in BBU; RRU or RSU;

Prepare XML file according to the Para, using LMT-

EOMS-offline;Prepare the software version

packet(.pkg file)

You can prepare the minimum configuration data XML just for transmission para,

or get the XML file of an old site,then to modify it according to the para of the new site

Go to the site, finish the SDR BS commission

See “SDR BS commissioning flow”

OMCR setting for the new site

OMCB setting for the new site

If we can use OMCB to connect to the SDRBS or

not ?

Finish other data configuration

(Radio Para) using OMCB remotely

synchronize the completed data to

the SDR by OMCB

Get the data back to OMCB from SDR

Observe the cell status, channel

status and signaling, using DMS

Observe the cell status, channel

status and signaling, using OMCB

Observe, analyse the alarms of SDR using EFMS

Observe, analyse the alarms of SDR

using Fault Management

Troubleshooting

Finish

Flow of Setting Up a New SDR BS

Install the hardware, provide

feedback to RNC/BSC

including boards and cable connection;

Check before powering up the SDR BS, then

power up

measure the input power and connections;

power up BBU first, then RRU/RSU

Connect PC to CC and upload the software

package (.pkg file)using the software

management of EOMS online

get the IP of CC board;modify the IP of CC if

necessary (need reboot CC);Add the pkg to lib, download

it , activate it;

Upload the prepared XML configuration data

file, finish the data configuration of boards

and connection

using EOMS online

Wait until SDR BS finishes the initialization

read LED indicators directly on boards,because meanwhile we will lost the connection between PC and SDR

Check the transmission status using

EOMS online

including E1/FE; HDLC; PPP; Global Port; IP; Ir Interface

Finish SDR BS commission

all status=normal?

SDR BS Commissioning

Other operations need to master: data backup; add a new board; replace a board; reset

boards(SW/HW); get VSWR/Output Power of certain RRU/RSU; block/unblock certain cells;

software version upgrade;