RF Optimization Tips_ WCDMA CSSR Optimization Tips
-
Upload
elatbarawi -
Category
Documents
-
view
220 -
download
0
Transcript of RF Optimization Tips_ WCDMA CSSR Optimization Tips
-
8/18/2019 RF Optimization Tips_ WCDMA CSSR Optimization Tips
1/5
-
8/18/2019 RF Optimization Tips_ WCDMA CSSR Optimization Tips
2/5
-
8/18/2019 RF Optimization Tips_ WCDMA CSSR Optimization Tips
3/5
overlap to make your CSSR is good and no handle unnecessary traffic and make nodeB
handle traffic heavily.
- Activate EFD(Enhanced Fast Dormancy) Feature
When fast dormancy, enhanced fast dormancy, or standard fast dormancy is applied, the UE
can request the RNC to release the PS signaling connection if no more PS data is being
transmitted. Upon receiving such a request, the RNC can either release the signaling
connection and put the UE into idle mode, or maintain the signaling connection and put the
UE through Cell_FACH to CELL/URA_PCH state to reduce battery consumption. The
descriptions about fast dormancy, enhanced fast dormancy, and standard fast dormancy areas follows:
- With fast dormancy, after receiving a Signaling Connection Release Indication (SCRI)
message from a UE, the RNC releases the UE RRC connection regardless of whether the
message contains the cause value "UE Requested PS Data session end."
- With enhanced fast dormancy, UEs send SCRI messages that do not contain the cause
value "UE
Requested PS Data session end" to the RNC. After receiving such an SCRI message, the
RNC moves
the UE through Cell_FACH to CELL/URA_PCH state.
- Standard fast dormancy is applicable to fast dormancy UEs that comply with 3GPP
Release 8 (R8 for short). With standard fast dormancy, UEs send SCRI messages thatcontain the cause value "UE
Requested PS Data session end" to the RNC. After receiving such an SCRI message, the
RNC moves
the UE through Cell_FACH to CELL/URA_PCH state. Standard fast dormancy is valid only
when theRNC has enabled the timer T323 in system information block type 1 (SIB1). You can
refer to the document on your vendor to activate EFD feature.
- Adjust CPICH Power Setting
You can adjust CPICH Power setting to reduce coverage and improve your CSSR Ex:
Change PCPICHPOWER from 330 to 300.
- Adjust Parameter QQUQALMIN
You can adjust QQUALMIN to improve CSSR and avoid congestion on blocking resourcesespecially during event with potential to increasing traffic. Example: Change Qqualmin from
-18 to -15 to avoid congestion.
You might also Need to know:
- How to Optimize Handover Success Rate in GSM Network
- CSSR Optimization for GSM
- Drop Call Rate Optimization in GSM and UMTS
- Power Control activation for Electricity Saving in Huawei GSM
▼ December (8)
TCH Block RateOptimizationTips inHuawei GSM
2G Voice QualityImprovementby TRXLayeringprior...
TBF DropImprovementtips in HuaweiGSM
GPRS PacketData AccessSuccessRate(PDASR)Improv...
Call Drop Rateimprovementby Parameter change in ...
Trial Power Control inGSM Huaweifor QualityImpr...
Power Controlactivation for ElectricitySaving in...
Handover Meaning in
GSM and Howto OptimizeHandov...
▼ November (3)
WCDMA CSSROptimizationTips
CSSROptimization
http://rfoptimization-tips.blogspot.co.id/2015/11/cssr-optimization.htmlhttp://rfoptimization-tips.blogspot.co.id/2015/11/wcdma-cssr-optimization-tips.htmlhttp://rfoptimization-tips.blogspot.co.id/2015_11_01_archive.htmlhttp://void%280%29/http://rfoptimization-tips.blogspot.co.id/2015/12/handover-meaning-in-gsm-and-how-to.htmlhttp://rfoptimization-tips.blogspot.co.id/2015/12/power-control-activation-for.htmlhttp://rfoptimization-tips.blogspot.co.id/2015/12/trial-power-control-in-gsm-huawei-for.htmlhttp://rfoptimization-tips.blogspot.co.id/2015/12/call-drop-rate-improvement-by-parameter.htmlhttp://rfoptimization-tips.blogspot.co.id/2015/12/gprs-packet-data-access-success.htmlhttp://rfoptimization-tips.blogspot.co.id/2015/12/tbf-drop-improvement-tips-in-huawei-gsm.htmlhttp://rfoptimization-tips.blogspot.co.id/2015/12/2g-voice-quality-improvement-by-trx_15.htmlhttp://rfoptimization-tips.blogspot.co.id/2015/12/tch-block-rate-optimization-tips-in.htmlhttp://rfoptimization-tips.blogspot.co.id/2015_12_01_archive.htmlhttp://void%280%29/http://rfoptimization-tips.blogspot.co.id/2015/12/power-control-activation-for.htmlhttp://rfoptimization-tips.blogspot.co.id/2015/11/drop-call-rate-optimization-how-to.htmlhttp://rfoptimization-tips.blogspot.co.id/2015/11/cssr-optimization.htmlhttp://rfoptimization-tips.blogspot.co.id/2015/12/handover-meaning-in-gsm-and-how-to.html
-
8/18/2019 RF Optimization Tips_ WCDMA CSSR Optimization Tips
4/5
Posted by hidayat encuh at 15:59
+1 Recommend this on Google
Sign out
Notify me
Enter your comment...
Comment as: atbarawi (Goo
Publish Preview
No comments:
Post a Comment
for GSM andWCDMA
Drop Call RateOptimization,How to iden tifyand f...
http://rfoptimization-tips.blogspot.co.id/2015/11/drop-call-rate-optimization-how-to.htmlhttp://rfoptimization-tips.blogspot.co.id/2015/11/cssr-optimization.htmlhttp://rfoptimization-tips.blogspot.com/logout?d=https://www.blogger.com/logout-redirect.g?blogID%3D1402525724257137611%26postID%3D320142044763873420https://www.blogger.com/share-post.g?blogID=1402525724257137611&postID=320142044763873420&target=pinteresthttps://www.blogger.com/share-post.g?blogID=1402525724257137611&postID=320142044763873420&target=facebookhttps://www.blogger.com/share-post.g?blogID=1402525724257137611&postID=320142044763873420&target=twitterhttps://www.blogger.com/share-post.g?blogID=1402525724257137611&postID=320142044763873420&target=bloghttps://www.blogger.com/share-post.g?blogID=1402525724257137611&postID=320142044763873420&target=emailhttp://rfoptimization-tips.blogspot.co.id/2015/11/wcdma-cssr-optimization-tips.htmlhttps://plus.google.com/104334418704430163819
-
8/18/2019 RF Optimization Tips_ WCDMA CSSR Optimization Tips
5/5
Newer Post Older PostHome
Subscribe to: Post Comments (Atom)
Simple templa te. Powered by Blogger .
https://www.blogger.com/http://rfoptimization-tips.blogspot.com/feeds/320142044763873420/comments/defaulthttp://rfoptimization-tips.blogspot.co.id/http://rfoptimization-tips.blogspot.co.id/2015/11/cssr-optimization.htmlhttp://rfoptimization-tips.blogspot.co.id/2015/12/handover-meaning-in-gsm-and-how-to.html