System Components

Stand with graphic(s) - 1Pole - 1 or more

Note:

Wider stands with more than one poleare more easily assembled by twopeople.

User Guide

1 2 3

6

5

4

1. Assemble pole by connecting theattached sections together. Do N O Ttwist the pole sections onceassembled as this can jam themtogether.

5. T o display the second graphic,on a twin, stand facing the pole andpull out the second graphic from thebase.

4 .

2. Place the base unit on the �oorput the assembled pole intothe socket hole of the rollerbanner stands base, tilt theunit back. Grip the header barof the graphic and slowly pullit up out of the unit.

3.

All of our retractablebanner stands work in

the same way.

6. Lean the unit towards you andattach the rail into the top of thepole. Hold the bannersthemselves to raise the stand intoan upright position.

If your stand has swing-out feet,they should not be swung-outuntil the banner(s) is up, as theywill otherwise prevent you fromleaning the stand towards you.

Always be careful when raising orlowering a banner that you do notscrape the banner edge againstthe stand end-plates. Simplykeep the banner away from theend-plates to avoid this byguiding it centrally.

Portable roller banner stand solutions from Coker Exhibition Systsems, Hook, Hampshire, RG27 9NY

Still with the unit leaning back,pull the graphic to the top andconnect it to the top of the pole

Once fully extendind andconnected return the bannerstand to an upright position.

Retractable Banner Stand Setup