R t lli tiRecrystallization Tt iTexture in Commercially...
18
R t lli ti T t i Recrystallization T exture in Commercially Pure (CP) Titanium Commercially Pure (CP) Titanium S. Panda 1 , G. Kumar 2 , S. C. Mishra 1 , S. Suwas 3 and S. K. Sahoo 1 1 Department of Metallurgical & Materials Engineering, NIT Rourkela, 769008, India 2 Department of Metallurgical Engineering & Materials Science, IIT Bombay, Mumbai 400076 India Mumbai, 400076, India 3 Department of Materials Engineering, IISc Bangalore, 560012, India
Transcript of R t lli tiRecrystallization Tt iTexture in Commercially...
R t lli ti T t iRecrystallization Texture in Commercially Pure (CP) TitaniumCommercially Pure (CP) Titanium
S. Panda1, G. Kumar2, S. C. Mishra1, S. Suwas3 and S. K. Sahoo1, , ,1 Department of Metallurgical & Materials Engineering, NIT Rourkela, 769008, India
2Department of Metallurgical Engineering & Materials Science, IIT Bombay, Mumbai 400076 IndiaMumbai, 400076, India
3Department of Materials Engineering, IISc Bangalore, 560012, India
Road-map
Introduction & Objectives
E i t l D t ilExperimental Details
Results & Discussion
Conclusion
Acknowledgement
9/5/2014 2
Recrystallization and Related Annealing Phenomenaby F. J. Humphreys and M. Hatherly, Elsevier Publication, 2004
Texture Development in Titanium and its Alloys:e tu e eve op e t ta u a d ts oys:
Recrystallization texture depends on both initial deformation condition andannealing temperature.
9/5/2014 3
Recrystallization Texture Development in CPTit iTitanium.
Effect of Strain Level and Strain Path on Texture Effect of Strain Level and Strain Path on TextureDevelopments in CP Titanium.
9/5/2014 4
CP-titanium(Grade-2)( )
Rolling ARB Processing Cross-Rollingg(90% Reduction)
g(6 Passes)
g(90% Reduction)
ARB: Accumulative
Progressive AnnealingRoll Bonding
9/5/2014 5
9/5/2014 6
ARB Process – A Schematic (D. Terada et. al.)
on
φ =0oφ1=0ocuss
i
φ1=0φ1 0
Rolling Cross-Rolling
& D
isc
ults
&R
esu
φ1=0o
ARB Processing9/5/2014 7
ec 1
0 se
ng
Ann
eali
0sec
Afte
r A
3m
in
1m
Rolling ARB Processing Cross-Rolling9/5/2014 8
2m
in
ing
Ann
eal
min
Afte
r A
5m
in
30m
Rolling ARB Processing Cross-Rolling9/5/2014 9
Different Orientation
Before Rolling
After Rolling
9/5/2014 10
1: (10 11)1: (10-11)2: (10-12)3: (10-13) 4: (11-24)
Before Annealing Annealed-10s Annealed-30s
(11 24) Orientations have highest stored energy values9/5/2014 11
(11-24) Orientations have highest stored energy values.
2m
in
ples
d S
am
min
nnea
le
5m
An
in
30m
Rolling ARB Processing Cross-Rolling9/5/2014 12
9/5/2014 13
Annealed for 2min
9/5/2014 14
Annealed for 5min
9/5/2014 15
Annealed for 5min
Annealed for 30min
9/5/2014 16
[11-25] fibre texture is observed during annealing ofcp-titanium.
Annealing texture development of ARB processed Annealing texture development of ARB processedsamples is insignificant.
9/5/2014 17
AcknowledgementProf. I. Samajdar for Texture Measurement.jGovt. of India for Financial Support.
Thank YouThank YouFor Your Kind Attention!
9/5/2014 18
![Surface recrystallization of single crystal nickel-based ...recrystallization behavior of SC superalloys are rarely reported [9,10]. Typically, recrystallization behavior of alloys](https://static.fdocuments.net/doc/165x107/5f2652b9bf73cd24c24d8552/surface-recrystallization-of-single-crystal-nickel-based-recrystallization-behavior.jpg)
