PTS-Clipping Method to Reduce the PAPR in ROF-OFDM System
description
Transcript of PTS-Clipping Method to Reduce the PAPR in ROF-OFDM System
![Page 1: PTS-Clipping Method to Reduce the PAPR in ROF-OFDM System](https://reader035.fdocuments.net/reader035/viewer/2022062222/5681585a550346895dc5b55d/html5/thumbnails/1.jpg)
Speaker : Chi-Han Yu
Author : Jianping Wang ; Ying Guo ; Xianwwi Zhou
From : IEEE Transactions on Consumer Electronics,
Vol. 55, No. 2, MAY 2009
1
![Page 2: PTS-Clipping Method to Reduce the PAPR in ROF-OFDM System](https://reader035.fdocuments.net/reader035/viewer/2022062222/5681585a550346895dc5b55d/html5/thumbnails/2.jpg)
Introduction PAPR Problem Simulations And Analysis Conclusions
2
![Page 3: PTS-Clipping Method to Reduce the PAPR in ROF-OFDM System](https://reader035.fdocuments.net/reader035/viewer/2022062222/5681585a550346895dc5b55d/html5/thumbnails/3.jpg)
The ROF(Radio Over Fiber) system has low transmission loss and ultra-wide bandwidth.
The OFDM(Orthogonal Frequency Division Multiplexing)system is the multi-carrier transmission technology especially in wireless communication system.
The combination of ROF and OFDM systems (ROF-OFDM) has attracted considerable attention for future gigabit broadband wireless communication.
3
![Page 4: PTS-Clipping Method to Reduce the PAPR in ROF-OFDM System](https://reader035.fdocuments.net/reader035/viewer/2022062222/5681585a550346895dc5b55d/html5/thumbnails/4.jpg)
The ROF-OFDM have one main disadvantages When the OFDM symbols which have high power entered to optical fiber, it will lead to dispersion and nonlinear.
Linear methods usually bring in marked increase in computational complexity.
Nonlinear methods usually bring in out-of-band radiation which can deteriorate the BER performance.
4
![Page 5: PTS-Clipping Method to Reduce the PAPR in ROF-OFDM System](https://reader035.fdocuments.net/reader035/viewer/2022062222/5681585a550346895dc5b55d/html5/thumbnails/5.jpg)
There is a new method combined the linear and nonlinear methods, named as Partial Transmit Sequence with Clipping (PTS-Clipping) to reduce the peak-to-average power ratio (PAPR).
It will bring in slight change to the BER performance between with and without clipping which makes it feasible to be used in real ROF-OFDM system.
5
![Page 6: PTS-Clipping Method to Reduce the PAPR in ROF-OFDM System](https://reader035.fdocuments.net/reader035/viewer/2022062222/5681585a550346895dc5b55d/html5/thumbnails/6.jpg)
The high power asks some devices for high performance and it must have high dynamic range, all of these requirements increase the system complexity.
We use the simply clipping combined with PTS method.
The main algorithm theory of PTS-Clipping method is to select a proper clipping threshold.
6
![Page 7: PTS-Clipping Method to Reduce the PAPR in ROF-OFDM System](https://reader035.fdocuments.net/reader035/viewer/2022062222/5681585a550346895dc5b55d/html5/thumbnails/7.jpg)
PAPR reduction with PTS
7
![Page 8: PTS-Clipping Method to Reduce the PAPR in ROF-OFDM System](https://reader035.fdocuments.net/reader035/viewer/2022062222/5681585a550346895dc5b55d/html5/thumbnails/8.jpg)
Clipping method sets a clipping threshold, when the amplitude of the signals over the threshold, then cut the high peak power, so that the peak power had a pre-distortion.
8
![Page 9: PTS-Clipping Method to Reduce the PAPR in ROF-OFDM System](https://reader035.fdocuments.net/reader035/viewer/2022062222/5681585a550346895dc5b55d/html5/thumbnails/9.jpg)
Where x(n) is the real band pass sample, y(n) is the clipped signal, and A is the clipped level.
We use a normalized clipping level, which we call the
clipping ratio (CR, CR = A 2 ).
9
![Page 10: PTS-Clipping Method to Reduce the PAPR in ROF-OFDM System](https://reader035.fdocuments.net/reader035/viewer/2022062222/5681585a550346895dc5b55d/html5/thumbnails/10.jpg)
The main idea of PTS-Clipping is to use the merit of PTS method and then use simply nonlinear clipping method to cut the high power value of these minority symbols and we add filtering after clipping.
10
![Page 11: PTS-Clipping Method to Reduce the PAPR in ROF-OFDM System](https://reader035.fdocuments.net/reader035/viewer/2022062222/5681585a550346895dc5b55d/html5/thumbnails/11.jpg)
The picture illustrates the PAPR performances that use PTS and PTS-clipping.
11
![Page 12: PTS-Clipping Method to Reduce the PAPR in ROF-OFDM System](https://reader035.fdocuments.net/reader035/viewer/2022062222/5681585a550346895dc5b55d/html5/thumbnails/12.jpg)
The picture respectively describe the performances of BERSNR of QPSK signals which are processed by PTS and PTS-Clipping.
12
![Page 13: PTS-Clipping Method to Reduce the PAPR in ROF-OFDM System](https://reader035.fdocuments.net/reader035/viewer/2022062222/5681585a550346895dc5b55d/html5/thumbnails/13.jpg)
In this paper we investigated the method of PTS and clipping on the performance of ROF-OFDM system.
The simulation results show that the proposed PTS-clipping scheme can provide better performance in terms of PAPR reduction when BER has been slightly changed.
13