PREPARATIONS TOOLS : 1 、 wire stripper 2 、 coating stripper 3 、 fiber length measurement 4...
-
Upload
deirdre-hunt -
Category
Documents
-
view
220 -
download
0
Transcript of PREPARATIONS TOOLS : 1 、 wire stripper 2 、 coating stripper 3 、 fiber length measurement 4...
PREPARATIONS
TOOLS:1 、 wire stripper 2 、 coating stripper3 、 fiber length measurement4 、 cutter
QUICK ASSEMBLY CONNECTOR
1
OPERATION
• First step : put on boot
Put on boot
2
• Second step : wire stripper
OPERATION
Fix the cable to this length and strip the jacket
3
• Third step : coating stripper
OPERATION
Strip length of coating 20mm
4
OPERATION
Fourth step : use alcohol to clear fiber
5
• Fifth step : fix the bare fiber and use cutting knife to cut the bare fiber( take care if the fiber end can be cut smoothly)
OPERATION
Fiber length measurement: 10mm
6
• Sixth Step : insert the fiber to the top of pre-embedded fiber and connect well
OPERATION
When the fiber reach the top , it comes bending
7
• Seventh step : Press the middle button (locked V-groove) to fixed the bare fiber.
OPERATION
Hold the cable tightly
8
• Eighth step : fix the cable and screw on tightly
Screw tightly for the boot
OPERATION
9
• Ninth step : move both side slightly when putting on the housing , in order to put on easily
OPERATION
10
• Tenth step : use the light pen to detect the fiber if connected well
OPERATION
11
• If reuse it , use clamps to open the locked button
Re-use
OPERATION
12
• Screw out the boot , put out the fiber. If the test data not good, pls repeat above steps to connect fiber again.
OPERATION
13