Practical lesson design a car

16
Practical Lesson

Transcript of Practical lesson design a car

Page 1: Practical lesson  design a car

Practical Lesson

Page 2: Practical lesson  design a car

Task

• At the End of the Lesson Participating students should be able to design a paper car

• To Make a paper car you'll need a hard paper, scissors, and a pen.

Page 3: Practical lesson  design a car

Step 1 Take a square of origami paper and place it on a table with the back side

facing up.

1

Page 4: Practical lesson  design a car

Step 2 Fold the top edge down to meet the bottom edge. Make a crease in the middle of the paper, and then unfold the paper to put it back in its original position.

.

Page 5: Practical lesson  design a car

Step 3Look at your paper. Mentally divide both the top half and the bottom half into thirds. Fold the top third of the top portion down.

Fold the bottom third of the bottom portion up.

.

Page 6: Practical lesson  design a car

Step 4 Take the bottom left corner of the portion that you just folded down on top of the paper. Pull the edge up and to the right to make a

triangular fold. Crease the paper.

.

Page 7: Practical lesson  design a car

Step 5 Fold the opposite corner (the top right corner) up and to the left to mirror the fold that you just made. Crease

the paper.

.

Page 8: Practical lesson  design a car

Step 6 Make identical folds to the one that you just made on top on the bottom flap. The bottom should be a mirror image of the top.

.

Page 9: Practical lesson  design a car

Step 7 Take the corners of the 4 triangles that you just folded. Fold the tips back behind the triangles. Doing this will round the corners to create the wheels.

.

Page 10: Practical lesson  design a car

Step 8 Fold the whole paper in half along the first crease that you made.

.

Page 11: Practical lesson  design a car

Step 9 Find the top right corner of the paper. Push the corner down to make a pocket fold. The pocket fold that you just made creates the trunk of the car.

.

Page 12: Practical lesson  design a car

Step 10 Examine the front half of the paper car where the windshield will go. Use scissors to cut a slit in the paper at the point where you want to

put the windshield. Cut to the right at a slight angle so that the windshield will slope like it does on a regular car.

.

Page 13: Practical lesson  design a car

Step 11 Push the corner down to create a pocket fold. This pocket fold makes the hood of the car.

.

Page 14: Practical lesson  design a car

Step 12 Draw windows, if you wish, to finish the car.

.

Page 15: Practical lesson  design a car

Finished.

.

Page 16: Practical lesson  design a car

Source

http://www.wikihow.com/Make-a-Paper-Car

building a Model car made of paper time lapseHow to Make a Toy Car