PHSAUTOMOTIVESALSPHSAUTOMOTIVESALS Tune-up Procedure.
-
Upload
theodora-williamson -
Category
Documents
-
view
214 -
download
2
Transcript of PHSAUTOMOTIVESALSPHSAUTOMOTIVESALS Tune-up Procedure.
PHS
AUTOMOTIVE
SALS
Tune-up Procedure
PHS
AUTOMOTIVE
SALS
There is no standard tune-up procedure below are listed certain things to check for, all steps may
not be applicable to all cars. Please check the manufactures
specifications.
PHS
AUTOMOTIVE
SALS
• A Tune up is very important to the operation of an engine because it can affect the following.
• 1. Engine power and acceleration
• 2. Fuel Consumption
• 3. Exhaust Pollution
• 4. Smoothness of engine operation
• 5. Ease of starting
• 6. Engine service life
PHS
AUTOMOTIVE
SALS
• Always observe safety precautions such as;• Hook up exhaust hoses or operate engine outside.• Remember that there are moving parts and many
parts of the engine and radiator that get very hot keep hands, tools and clothing away from these.
• Caution, Cooling fans can come on at any time.• Fuel Pressure can be very high please relieve
system pressure.• Block the drive wheels and apply the parking
brake.• Wear eye Protection
PHS
AUTOMOTIVE
SALS
• 1. Check all fluid levels.
• 2. Road test the vehicle if necessary to verify certain problems.
• 3. Inspect hoses and belts, and replace as necessary.
• 4. Check cooling fan operation.
PHS
AUTOMOTIVE
SALS
• 5. Inspect the general condition of vacuum hoses and electrical wires.
• 6. Clean battery terminals and check cable condition.
• 7. Perform battery load test, Check the voltage and perform battery hydrometer test if possible; determine battery condition.
• 8. Check alternator maximum output and normal voltage setting; determine charging system condition.
PHS
AUTOMOTIVE
SALS
• 9. Check starting motor current draw; determine starting motor condition.
• 10. Perform compression test or cylinder power balance test.
• 11. Replace spark plugs.
• 12. Test spark plug wires and replace as required.
PHS
AUTOMOTIVE
SALS
• 13. Test and inspect distributor cap and rotor, and replace as necessary. (distributor type ignition system)
• 14. Test maximum coil voltage; replace coil if necessary.
• 15. Check ignition timing; adjust if necessary.
• 16. Test fuel pump pressure; and replace fuel filter.
PHS
AUTOMOTIVE
SALS
• 17. Check and replace air filter.
• 18. Check heated air inlet system operation.
• 19. Check injector balance. If carburetor, check choke and idle operation.
• 20. Inspect fuel system for leaks.
PHS
AUTOMOTIVE
SALS
• 21. Clean injectors if necessary or add some fuel injector cleaner to the tank.
• 22. Check emissions devices such as PCV, EGR, and canister purge systems for proper operation. (Replace PCV filter or wash in approved solvent if reusable)
• 23. Check engine computer system for fault codes. (Check operation of the O2 Sensor.)
PHS
AUTOMOTIVE
SALS
• 24. Check 4 gas operation make sure it will pass an emission test.
• 25. Road test the vehicle to be sure there are no performance problems.
PHS
AUTOMOTIVE
SALS
The End for this cap and rotor