VISUAL COMMUNICATIONS GRAPHICS MR. SHEA PIN HOLE CAMERA / PARTS OF A CAMERA.
Photography By: Jarrett Waller. Portfolio Pin Hole Camera The pin hole camera was the first project...
-
Upload
godwin-hodges -
Category
Documents
-
view
216 -
download
0
Transcript of Photography By: Jarrett Waller. Portfolio Pin Hole Camera The pin hole camera was the first project...
Pin Hole Camera
• The pin hole camera was the first project we did this year. We took a oatmeal container and put a hole in the center. The hole was to expose the film.
Developing Negatives
Print Process• Put negative in developer for
1:30.
• Then it goes into the stop bath for 30 seconds.
• After that it goes into the fixer for 5 minutes.
• Last it goes into the water for 5 minutes.
Cropping• First you get a contact strip.
• Then you get a negative.
• Next you put the negative in the enlarger.
• When it is in the enlarger use the correct expose time.
• Last you expose film and develop it.
Photoshop Tutorials
Enhancing Iris Color• First you get a picture.
• Then open the picture in Photoshop.
• Next you copy the picture and save the original.
• On the copied picture, use tools to change the color of the eye of the subject in picture.
Dodge and Burning• First you download the file.
• Next you open the picture in Photoshop.
• Then you use the dodge and burning tool to burn out the lights in the photo.
• Then you’re done.
Example Of Enhancing Iris Color
• Look at the right eye of the object. In the picture on the left the eye is regular. In the picture on the right the eye is red.
Example Of Dodge And Burn
• In the picture to the left, underneath the tower the lamps were burned out of the picture. In the original picture the lamps were visible.
Assigned Photography
Panoramic• First you take three pictures in
the same area.
• Then you open all three of them in Photoshop.
• Next you put all three of them onto one layer and merge them together.
• When they are merged together it should look like one long picture.
Matted Photograph• First you take a picture and
open it up in Photoshop.
• Then you change the measurements of the picture to 5 by 7.
• Next you get the matted paper and cut the paper to the correct measurements.
• Then you print the picture and tape it onto the back of the matted frame.