PHOENIX CUT CHARTS for the OXY-FUEL CUTTING … · PHOENIX CUT CHARTS for the . OXY-FUEL CUTTING...
Transcript of PHOENIX CUT CHARTS for the OXY-FUEL CUTTING … · PHOENIX CUT CHARTS for the . OXY-FUEL CUTTING...
PHOENIX CUT CHARTS for the OXY-FUEL CUTTING PROCESS
• For decades CNC controls used for oxy-fuel cutting were concerned only with the cutting path.
• In the past, process control was the responsibility of the machine operator.
• The demands of industry require that today’s CNC controls assume responsibility for BOTH path and process parameters.
• Controlling only path is no longer enough.
OXY FUEL CUT CHARTS
Page 2
• The Hypertherm CNC control offers control of the oxy-fuel process to the fullest extent possible for the configured oxy-fuel gas system.
• If the process parameter cannot be CNC controlled, the cut chart displays the recommended value.
• Machines with a SERCOS interface and electronic pressure transducers allow the cut chart to fully control the process parameters.
• The following slides are screen captures of the Hypertherm Phoenix motion control software configured with CUT CHART support for operation of a Harris oxy-fuel torch and a machine with a SERCOS interface and electronically controlled pressure transducers .
OXY FUEL CUT CHARTS
Page 3
OXY FUEL CUT CHARTS
Digitally controlled pressure transducers
Page 4
OXY FUEL CUT CHARTS
Machine operator presses the Oxy Fuel CUT CHART button to open the cut chart screen.
Page 5
OXY FUEL CUT CHARTS
Process Selection drop drown menus are used by machine operator to set up a cutting process.
Page 6
OXY FUEL CUT CHARTS
Cutting parameters above are dynamically filled in based on selections made in the Process Selection drop down menus.
Page 7
OXY FUEL CUT CHARTS
Operator selects torch type
Page 8
OXY FUEL CUT CHARTS
Operator selects fuel gas
Page 9
OXY FUEL CUT CHARTS
Operator selects thickness
Page 10
OXY FUEL CUT CHARTS
Cutting tip # is displayed
Page 11
OXY FUEL CUT CHARTS
Changes made to CUT CHARTs are SAVED by pressing SAVE PROCESS button
Values in blue text indicate custom user values.
Page 12
OXY FUEL CUT CHARTS
Press RESET PROCESS button to return that process screen to factory settings.
Values return to factory settings.
Page 13
OXY FUEL CUT CHARTS
Press SAVE CUT CHARTS to save all charts to a memory stick for storage outside of the control.
Page 14
OXY FUEL CUT CHARTS
Press LOAD CUT CHARTS to load cut charts from a memory stick. Updated charts are available as required at www.hypertherm.com
Page 15